20 Most Recent 2007 Hyundai Santa Fe - Page 4 Questions & Answers


Its 11 thousand indian rupees as on 1 July 2014 6818a50b-0a6f-4e16-9b34-fc08f3c4d0e1.jpg

Hyundai Santa... | Answered on Jul 01, 2014


Early airbag (or SRS) systems used only one sensor but later vehicles used several sensors possibly daisy-chained together, at least one of which would be fixed to the front bulkhead behind the dashboard...

Hyundai Cars &... | Answered 2 days ago


All the knowledge you need is in service and repair manual with diagram and you will get the manual from the given link https://toolsnyou.com/

Hyundai Cars &... | Answered 2 days ago


Does the effect both the Front and Rear or just one? Does it work when you use the Emergency Flasher? If so, then we know that the fuse and bulb are good. If it worked with the Emergency Flasher then problem would reside in the Turn Signal Stalk or the wiring leading to it. I generally look for loose connectors or plugs. If it did not work replace the bulb. If that does not resolve the issue I would follow the ground wire from the bulb to make sure that there is a good ground. Without the ground you do not have a complete circuit.

Hyundai Cars &... | Answered 3 days ago


The service and repair manual with diagram will provide you step by step help to locate and fix the problem easily and you will get the manual from the given link https://toolsnyou.com/

Hyundai Cars &... | Answered on Nov 07, 2019


Fob didn't work so the alarm immobiliser was armed and active when the locksmith opened the car - with predictable results.

Fob still not working - broken or needs new battery. Have you fitted a new battery into the fob?

The alarm immobiliser will probably remain armed until the doors have been locked and then unlocked with the fob.

There is a small chance the system can be fooled into thinking it has been disarmed by disconnecting the battery (overnight if poss) and then with the door open and the ignition key in and turned on, when the battery is reconnected it might be possible to start the engine...

Hyundai Cars &... | Answered on Nov 06, 2019


if this is a manual transaxle the reverse lamp switch is just behind the battery box beside the slave cylinder mount. if this is an automatic transaxle it is built into the trans range switch that shift cable moves on top of transmission.

Hyundai Cars &... | Answered on Nov 03, 2019


this has two fuses for clock in under dash fuse box fuse 11 10amp and fuse 3 15 amp

Hyundai Cars &... | Answered on Nov 03, 2019


Hyundai has a tsb on this code it is 16-at-005 basically it breaks down to this: remove air cleaner find extension motor wire disconnect and measure resistance on pins 2 and 7 which if looking at male pins top row from left over 2 and bottom from left over 2 is pin 7 resistance is 112-142 kila ohms now disconnect trans temp sensor connector measure the resistance on pin 4 top row from left and pin 8 bottom row from left should be same 112-142 kila ohms at outside temp 68 . if reading are not the same resistance replace transaxle,if they both are same resistance replace HPCU (hybrid power control unit ) next step if resistance is different by 1 ohm harness is good,if resistance on both readings are different by more than 1 ohm replace extension wire . may need to send this car to dealership if this testing is more than you can provide yourself,sorry hope it helps

Hyundai Cars &... | Answered on Nov 03, 2019

Not finding what you are looking for?
2007 Hyundai Santa Fe Logo

Popular Tags

106 questions posted

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Santa Hyundai

  • Santa Hyundai

Most Popular Question

2007 santa fe blows hot passenger side

  • Cars & Trucks
Loading...