20 Most Recent 2005 Ford Crown Victoria Questions & Answers


Sensor is in the front on the radiator support clean the connection and check the fuse also the wires for continuity

2005 Ford Crown... | Answered 20 hours ago


Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try

2005 Ford Crown... | Answered on Aug 26, 2019


change the light control module. it is located under the dash near your right knee on the drivers side. this is a common problem with crown vics.

2005 Ford Crown... | Answered on Jul 20, 2019


The problem is fairly common in this car. The solution is the Headlight Control Module, or Lighting Control Module. My car did the same thing, they would go off, and come right back on. Then one day they went out and stayed out for 12 minutes. I changed the HCM and they never did it again. It is a box under the dash on the drivers side, right above your right shin if you were driving.

2005 Ford Crown... | Answered on Jul 13, 2019


Try pushing on the lenses to turn off.

2005 Ford Crown... | Answered on Jul 04, 2019


Injector on that cylinder may be restricted or failing electronically .

2005 Ford Crown... | Answered on Feb 12, 2018


It's actually a relay inside the LCM. I opened mine and replace all four for $16 total. You have to be able to solder the leads to a printed wiring board. Not hard if you can solder. Fixed mine...

2005 Ford Crown... | Answered on Dec 01, 2017


Electronic's ,go figure .. Not all gliches set code's . Could be any number of thing's - sensor's , modules etc..... A professional Tech would have trouble finding what was wrong , even with profession diagnostic test equipment , scanners etc..... It would be better if it died an wouldn't start back up . Check for TSB'S -
technical service bulletins. Check battery an connection's , loose wire's for sensor's etc... engine . That's about all you could do. Hooking up a professional scan tool an checking engine sensor data inputs to the PCM - engine computer . There maybe a bulletin for a reflash of the PCM .

002 Fuel System Tests Start Here

2005 Ford Crown... | Answered on Nov 11, 2017


Scanner not communicating with the computer is most likely a fuse.

2005 Ford Crown... | Answered on Aug 25, 2017


Po7055 is not a valid fault code, please recheck, valid codes look like this PXXXX the X's are numbers, four of them

2005 Ford Crown... | Answered on Sep 27, 2016


Do you know if your door locks are module controlled or non module controlled ?
Locks, Latches and Entry Systems - Module Controlled
Principles Of Operation
s5a~tr~en~file=ani_caut.gif~gen~ref.gif CAUTION: Do not use a key, pencil or any other hard object to press the keyless entry keypad buttons. These objects may damage the keyless entry keypad buttons.
NOTE: The remote transmitter will not operate with the transmission in REVERSE or DRIVE.
NOTE: Upon installation of a new driver door module (DDM), the module must be reconfigured. Refer to Section 418-01 .
The DDM receives inputs from the digital transmission range (TR) sensor, ignition switch, brake switch, door lock control switches, lighting control module (LCM), keyless entry keypad and remote transmitter. The DDM outputs consists of keyless entry keypad illumination, door lock actuators, luggage compartment lid release solenoid, and LCM.
For DDM removal and installation information, refer to Section 419-10 .
Inspection and Verification
s5a~tr~en~file=ani_caut.gif~gen~ref.gif WARNING: If equipped with fire suppression system, refer to Section 419-03 for important safety warnings.
NOTE: Before starting electrical diagnosis, check for mechanical binds by manually operating the door locks. Operate lock system several times from each switch while observing the operation of all door locks. Be sure battery is fully charged.
  1. Verify the customer concern.
  1. Visually inspect for obvious signs of mechanical and electrical damage.
  2. Visual Inspection Chart Mechanical Electrical
    • Binding latches
    • Battery junction box (BJB) fuse 8 (20A)
    • Central junction box (CJB) fuse(s):
      • 10 (5A)
      • 18 (10A)
      • 25 (10A)
    • Circuitry
    • Connectors
    • Door lock actuator
    • Door lock control switch
    • Keyless entry keypad
    • Luggage compartment lid release switch
    • Luggage compartment lid release solenoid

    1. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
    1. If the cause is not visually evident, connect the diagnostic tool to the data link connector and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
      • check that the program card is correctly installed.
      • check the connections to the vehicle.
      • check the ignition switch position.
    1. If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
    1. Carry out the diagnostic tool data link test. If diagnostic tool responds with:
      • SCP or ISO circuit fault; all electronic control units no response/not equipped, refer to Section 419-10 .
      • No response/not equipped for the DDM, refer to Section 419-10 .
      • No response/not equipped for the LCM, refer to Section 419-10 .
      • System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs and carry out self-test diagnostics for the DDM and LCM.
    1. If the DTCs retrieved are related to the concern, go to the Driver Door Module (DDM) Diagnostic Trouble Code (DTC) Index or Lighting Control Module (LCM) Diagnostic Trouble Code (DTC) Index to continue diagnostics.
    1. If no DTCs related to the concern are retrieved, GO to Symptom Chart .
    Drive Door Module (DDM) Diagnostic Trouble Code (DTC) Index DTC Description Source Action B1352 Ignition Key In Circuit Failure DDM Go To Pinpoint Test H . B1396 Door Lock Circuit Short To Battery DDM Go To Pinpoint Test C . B1526 Keyless Entry Keypad Circuit Short To Ground DDM Go To Pinpoint Test E . B1553 Luggage Compartment Lid Release Circuit Short To Ground DDM Go To Pinpoint Test B . B1751 Park/Neutral Switch Circuit Short To Battery DDM Go To Pinpoint Test L . B2425 Remote Keyless Entry Out Of Synchronization DDM Go To Pinpoint Test M .
    Lighting Control Module (LCM) Diagnostic Trouble Code (DTC) Index
    DTC Description Source Action B1300 Door Lock Circuit Failure LCM Go To Pinpoint Test N . B1310 Door Unlock Circuit Failure LCM Go To Pinpoint Test N . B1396 Door Lock Circuit Short To Battery LCM Go To Pinpoint Test N . B1397 Door Unlock Circuit Short To Battery LCM Go To Pinpoint Test N . B1677 Alarm Panic Input Circuit Failure LCM Go To Pinpoint Test J . B1679 Alarm Panic Input Circuit Short To Battery LCM Go To Pinpoint Test J .
    NOTE: For a complete list of DDM and LCM DTCs, refer to Section 419-10 .
  3. ????????????? Do you have a professional scan tool ?
    ??

2005 Ford Crown... | Answered on Sep 17, 2016


How many miles are on it?

2005 Ford Crown... | Answered on Aug 11, 2016


no! this code is a ignition code means you have a coil problem,your a/c is there enough freon in the system,if so then next check low preasure cut off switch/ or also called cycle swith, unplug and jump connection see if compressor truns on.start here.

2005 Ford Crown... | Answered on Jun 05, 2016


The OD light is blinking because the transmission control module has detected a fault in the transmission operation, most common is slipping as measured by the input and output turbine shaft speed sensors. You may feel no slipping but the sensors are detecting it or one of the sensors is giving a fault signal.

2005 Ford Crown... | Answered on Apr 06, 2016


Sounds like it could be the the transmission or the gear box. Also what's going on with the axel rod?

2005 Ford Crown... | Answered on Feb 12, 2016

Not finding what you are looking for?
2005 Ford Crown Victoria Logo

338 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Crown Victoria Ford

  • Crown Victoria Ford

Most Popular Question

diagram 2005 ford crown victoria outer

  • Cars & Trucks
Loading...