20 Most Recent 2001 Jeep Grand Cherokee - Page 6 Questions & Answers


Your lifters ride on your camshaft. You must remove your intake manifold to get access to your lifters. And you can not just replace the lifters! Your engine is a flat tappet cam and lifter setup, you must replace all 16 lifters along with the cam and a proper break in procedure must be followed, and I highly suggest a ZDDP break in additive be used. And there will still be a good chance of the cam wearing out upon break in thanks to our legislators removing the natural zink and phosphorus lubricants from engine oil.

2001 Jeep Grand... | Answered on Jan 30, 2016


no engine stated, there are 2
which one, (emmisons page shows a v8 for this code)
ticking can come from many place. inside or outside engine
even a loose bracket
find a real mechanic? an ASE shop:.??????
win
p0358 is fed,code, (means standardized P0 means that)

buy a $5 stethoscope hand to your mech, and tell him
find location now. win
at the least (ah its inside engine or out)
dah?
and if outside he listens to all those objects spinning for noise
and loose or broken brackets.

it the V8, 358 means cop #8 has problems
358 means, coil primary current is too low
means coil is bad #8
or the pins to it rust
or wire bad to it.

so next ask where is*8?
behind #6

on v8
#1 is most forward cylinder
on this block that be left front
so 2,4,6,8 be bank2 and right side rear.

reset the dtc? did you key on with the #8 cop unplugged, if yes that a false code.
reset the system.
push the 0bd2 scan tool reset button,,,,,
if 385s return it's real ,fix that.
"reseat" the cOPS connector?

ticking takes live humans to find
we are 100% not that here.
we are cloud bunnies.

2001 Jeep Grand... | Answered on Jan 21, 2016


the new key is not programmed to the immobilizer take it to a service center that can program keys to the vehicle ECM unit

2001 Jeep Grand... | Answered on Dec 25, 2015


Please don't overlook the importance of a good battery with clean/tight post connections...try disconnecting both + and - clean terminals and cables and reconnect...the brain should also re-set...Hope this helps.

2001 Jeep Grand... | Answered on Oct 29, 2015


Check under the hood----there's a big fuse box that also contains relays for various components and more then likely it's there----also check your owners manual for fuse/relay location----in addition there's a relay block next to the fuse box on some vehicles----not busting on you by why do you think it's the relay---others things can contribute to the fan not working---switches---low refrigerant----vacuum control switch (leak in vacuum line) etc etc

2001 Jeep Grand... | Answered on Oct 14, 2015


Check your throttle body on the intake for carbon buildup. Open the hose to the intake inlet and check that plate that moves when you depress the gas pedal (while not running). Clean debris with damp washcloth, not soaking wet. If a lot of debris the idle air control valve, and chamber will need cleaned.

2001 Jeep Grand... | Answered on Oct 02, 2015


RENAULT MASTER DCI 120
Registreringsnummer
AE 19053
Understellsnummer
VF1FDC1HH39195287
Registrerings?r
2008
8200633634T
X043 Security I am Luan Bytyci I nyd code Luan · Sep 13 2015, 02:13 PM

Hei ka dere sende radio kode for Renault Master 2008 .8200633634TX043

Pr

2001 Jeep Grand... | Answered on Sep 14, 2015


If it ran prior to the filter replacement, it will most likely be a filter issue. Installed backwards? You have to allow fuel pressure to build back up and fill the new filter before it will start. You can try cranking the engine while applying the gas pedal slightly to see if it will start

2001 Jeep Grand... | Answered on Aug 31, 2015


No it can't. On yours, it is most likely a door latch. Fobs will bypass the latch, but you have to have one.

2001 Jeep Grand... | Answered on Aug 29, 2015


May be,some car do not have it.

2001 Jeep Grand... | Answered on Aug 29, 2015


If your keys are grey than they have to be programmed at a Jeep dealer. If you keys are black they do not need to be programmed. A good locksmith may also be able to help you with this.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

2001 Jeep Grand... | Answered on Aug 15, 2015


does it crank or not.?????
the IMMObilizer on this car does NOT cut cranking .
it cuts fuel (then spark) it only prevents running....
so what is next, easy!
is the IMMO lamp off in dash?
do say what step fails.
  1. you insert the key.
  2. turn to ign, on.
  3. the CEL glows (dash and the immo glows and goes out)
  4. the IMMo must not flash. (or see"NOkey" in dash)
  5. if the IMMo does not go out, it will never start (by design)
  6. it might run 2 seconds, but that is of on concern... it needs run to drive.
here are some SKIM /SKIS (IMMO) features

http://www.fixkick.com/Jeeps/SKIM.html

what is lamp 12 doing in the photo. on your car.?
the lamp location varies by year, and model jeep.
the operators guide tell you where it is..

2001 Jeep Grand... | Answered on Aug 15, 2015


it needs to be scanned.
scan the air bag controller

2001 Jeep Grand... | Answered on Jul 24, 2015


this is a permanent job!

2001 Jeep Grand... | Answered on Jul 14, 2015


There isn't one, just a circuit breaker. If one window works or you hear noise, it is good. Jeeps are notorious for bad window regulators. They come with the motor.

2001 Jeep Grand... | Answered on Jul 05, 2015


When the anti theft system was created,the dealers forgot to tell the new car buyers about how much the fob matters to the vehicle,without it,owners are stuck,your anti theft device is activated,you need to lock and unlock your doors a couple times with the key fob,not the key,and then you need to put the key in the ignition and start it,if you dont have your key fob,call your car dealer to get a new one,they are programmed for each car only,you cannot bypass it.if you lost your fob or never had it,whatever,you need to have the exact fob that came with that car from the factory,the key and fob have a chip in them that only go to that certain car,if you do not have it,then you need to buy a new one from the dealer or ebay and then you need to contact your dealer about programming the fob to your car,you might not have to have it towed if they have the documents from the car,the only other way is to get a junk car,with the steering column,key,fob and all computer boxes and door locks and switch them,i just did that with a 98 dodge dakota,and it works.

2001 Jeep Grand... | Answered on Jul 04, 2015


In most cases the shifter button is controlled by a solenoid activated by a switch on the brake pedal when the pedal is depressed. If the button will not release there may be a problem with the brake pedal switch ( Do the brake lights work when the pedal is pushed? ) the shifter release solenoid or wiring. There may be an override to release the button somewhere near the shifter. Check owners manual to see if equipped with safety release button

2001 Jeep Grand... | Answered on Jun 28, 2015


that sounds like a wiring problem , i'm not sure if the wiring for the wiper is a loom that connects to the liftgate near the hinge area, or is a connector plate by the lock catch ,you will be able to see which it is as very obvious between the two systems , if is the wiring loom look for signs of wear etc , the light is usually by a button switch that is activated when opening liftgate if no button switch visable then it will most likely have a mercury switch inside the liftgate , either way will need to remove the gate interior trim to check out the problem and also you will then be able to check if the wiper motor is getting power , i should have started with check the rear wiper fuse , hope this helps

2001 Jeep Grand... | Answered on Jun 26, 2015


If equipped with a 4lt engine I would suspect a crank sensor or ignition coil issue to cause this problem especially with higher mileage. You may also have a fuel delivery problem ( fuel pump ) causing this issue. Is the check engine light on? If so have the codes scanned for any crank senor problems. The crank sensor and or ignition are problamatic on these engines with high mileage

2001 Jeep Grand... | Answered on Jun 08, 2015

Not finding what you are looking for?
2001 Jeep Grand Cherokee Logo

3,392 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Grand Cherokee Jeep

  • Grand Cherokee Jeep

Most Popular Question

2001 jeep grand cherokee speedometer not

  • Cars & Trucks
Loading...