Question about 2000 Jeep Grand Cherokee
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The park,brake light sockets have a tendency to melt. I would try swapping the turnsignal socket with the brake light socket and see if it works. They just twist out.
Posted on Nov 25, 2008
Check this link & scroll down to your engine. Click on picture to expand.
Posted on Feb 03, 2009
SOURCE: 2002 jeep cherokee laredo
My 98 Jeep Grand Cherokee had the same problem. Over heated when standing still. Took it to dealer and they could not find any problem with cooling fan. After doing my own investigation I found out that the electric cooling fan would begin to seize up after about 1hr. of operating. (gets hot)
The dealer would look at fan and see that it was running and think its ok. The problem is, it wasn't running fast enough.
I have a relay on the right side of front fender and jumped the fan to stay on with motor off. (must know what your doing). After about 1hr. fan started slowing way down. Returned it to dealer told them what the problem was. They were not smart enough to jump the relay so they put a couple hundred miles on it even though i told them it works OK when moving. Make sure you tell dealer to use the relay to jump.
Replace cooling fan motor. Works great
Posted on Feb 27, 2009
First, I want to say thank you for the info, you saved me money and aggravation. Second it took mea little while to figure out what contact I was looking for. So I would like to provide a little more detail to make it easier for others in the future.
This is the corrective method for your brake lights not working when your headlights are on(2000 Jeep Cherokee Larado).
1) The cause of the problem is heat from the bulb.
2) Remove the light assembly as if you were going to change a bulb.
3) Turn the socket and remove it from the taillight assembly and set it aside(check to be sure your bulb is not burnt out).
4) Look at the opening, you will see 3 flat chrome colored contacts on the assembly.
5) Notice the one by it self at the top of the opening, that is the "ground".
6) If you look closely you will notice the plastic around the ground contact has shrunk a little bit, this caused the contact to pull away from the socket, causing the problem.
7) With a small flat head screwdriver, VERY GENTLY pry up the contact so it stays slightly upward by itself.
8) Re-insert the bulb assembly back into the housing and press your brake petal with your lights on.
9) You should be in good to go!
10) Tools: Phillips head screwdriver and a small flat head screwdriver.
11) Time : 5 minutes per light
Posted on Jun 08, 2009
Tips for a great answer:
Oct 26, 2016 | 2000 Jeep Grand Cherokee Laredo
Dec 17, 2012 | 2000 Jeep Grand Cherokee
May 01, 2012 | 1999 Jeep Grand Cherokee
Apr 07, 2012 | 2000 Jeep Grand Cherokee
Mar 20, 2011 | 2000 Jeep Grand Cherokee
Mar 27, 2010 | 2000 Jeep Grand Cherokee
Nov 19, 2009 | 2001 Jeep Grand Cherokee
Nov 06, 2009 | 1994 Jeep Grand Cherokee
Sep 03, 2009 | 2001 Jeep Grand Cherokee
May 13, 2009 | 2000 Jeep Grand Cherokee
228 people viewed this question
Usually answered in minutes!