Question about 2005 Jeep Grand Cherokee

Open Question

Heated seats in 2005 jeep grand cherokee

When I press the heated seat buttons for either the passenger or driver seats the indicator does not light up nor do the seats heat up. Could this be as simple as a fuse? I have looked in the owners manual and can't seem to find where that fuse might be. Hey thanks for any help you might have for me.

Craig

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2001 jeep grand cherokee seat removal

i actually removed my 2 front seats very easily as a novice. There really is only i think 4 bolts that need to come out 2 in front and 2 in back. If i can remember correctly i believe it was a larger metric size. Although i dont have power seats, if you do just look for the clip connector and disengage

Posted on Jul 07, 2008

Ad
  • 4 Answers

SOURCE: air conditioner leaks (drains)into the front passenger seat floor mat

I had the same problem. Drilled a hole in the round plastic extension beneath the glove box, behind the carpet. Now run a coat hanger through it, followed by alot of compressed air. It may take several times, debri from above may be continuosly replugging drain. when you are done, clean thoroughly, and patch with hot melt glue. Good luck.

Posted on Sep 16, 2008

Mikey108
  • 475 Answers

SOURCE: power seat

Try hitting the seat motor lightly with a small hammer while operating the switch.

Posted on Oct 31, 2008

  • 20 Answers

SOURCE: 2001 Jeep Grand Cherokee which fuse controls heated seats?

Fuse # 20, located in the Junction Block (interior, drivers side). This is a ten amp fuse.

CLICK_HERE

Read the information at the above site. The TSB (technical service bulletin) may be of interest to you.

Posted on Nov 20, 2008

motor1258
  • 6674 Answers

SOURCE: heated seat 1996 jeep grand cherokee

C1 & C2 in your panel are most likely one of the culprits, if no power at heater at seat. Sounds like testing for power at seat switch is easier to do than get at these circuit breakers in the panel. If you have power at switch at seat, then it's not the fuse/circuit breaker. Good reading at this link for you.


http://www.wjjeeps.com/seats/seats.htm#HEATED

Posted on Dec 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the on button to turn on the heated seats in a 2007 ford five hundred? I just got the car and I don't know where it is and I was told there was heated seats.


The heated seats are a luxury feature that heat the front seats. This provides maximum comfort for the driver and the front passenger. To turn on the heated seats, press the heated seat button, which is a picture of a seat. There are two of these buttons, and each are located on the center console. The button on the driver's side of the console controls the heat for the driver's seat, while the button on the passenger's side of the center console controls the heat for the passenger's seat. Pressing the heated seat button will turn the heated-seats onto their highest setting. Pressing the button a second time will lower the heated seats to their medium setting. Pressing the button a third time will result in the lowest setting. Pressing the button a fourth time will turn off the heated seats. There are three lights next to the heated seat buttons to indicate what setting the heated seats are on.
Tip
The heated seats will only work when the engine is running.

Mar 24, 2018 | Ford Cars & Trucks

2 Answers

What number is the fuse for front passenger power seat in 2005 grand Cherokee? Location is under the dash , but what # is it ? Size of fuse ?


Does your Jeep have memory seats ? Power seats have a circuit breaker not a fuse .One circuit breaker powers driver and passanger seat's . Did you look under the seat for unconnected wire's , anything blocking the seat . circuit breaker #2 20 amp . Check for battery voltage at the switch . Black with red stripe wire .

Feb 19, 2017 | 2005 Jeep Grand Cherokee

1 Answer

Where is the fuse for the heated seats in a 2007 jeep grand cherokee laredo?


Remove the ignition key. Unplug the HSM (heated seat module). It is under the passenger seat. You can easily accomplish this with the seat all the way back. Wait a few seconds they plug it back in. Start the engine. Turn the seats on. If the indicator lights come on for 2 seconds and then go out, further diagnostics is required. Hopefully they'll stay on and the seats will be working fine.

Thanks,
Ron

Feb 12, 2012 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Heated seats do not work


First off, I would contact your local Jeep dealer and have them run your VIN # to check for any recalls. The 1999-2004 Grand Cherokees had a recall on the seat heaters. If your vehicle doesn't fall into the VIN # range then either your seat heater switch has gone out, or you have a broken element in the seat heater. I have replaced more seat heaters than switchsm the elements heat up and break. Hope this helps out.

Best of luck

Jun 16, 2010 | 2001 Jeep Grand Cherokee

1 Answer

2002 jeep grand cherokee heated seat quit working only the driver side passenger side still works


hi
contact your jeep dealer as there was a recall for the grand cherokee heated seat pads as some of them heated to much and set the seat on fire... they will replace them free off charge.
hope this helps

Feb 28, 2010 | 2002 Jeep Grand Cherokee

1 Answer

Drivers heated seat not working


check the fuse for the dash for the seats.

Jul 21, 2009 | 1998 Jeep Grand Cherokee

1 Answer

Heated seats


Likely, the heating element in the seat has failed. The reason is simply that the drivers seat is in use more than any other seat in the vehicle. You can check continuity of the element with an ohmeter across the seat side of the heater connector. Check for power at the harness side with a volt meter. If there is power but no continuity, heater element has failed. Personally, I'd probably just live with it but you can either attempt to install a new heater element or if you can find a similar seat in a salvage yard, just buy it and put it in! (whole seat probably costs less than the element!!!

Dec 13, 2008 | 2002 Jeep Grand Cherokee

1 Answer

Heater seats dont work but light comes on.


Ok it is obvious since the light is coming on you are getting power to the switch. It could be a heated seat relay. Im fairly sure jeeps use a relay after the switch that is where I would start. Check and see if the Heated seat relay, and fuse are good

Dec 11, 2008 | 2001 Jeep Grand Cherokee

2 Answers

Heated seats are not working but light is on


Sounds like the same problem I had. I brought it to the Jeep dealer and they told me that the heating element in the seat stopped working. They told me that the only way to repair was to take the seat apart and replace the heating element in the seat. Of course they will charge you the standard $80 to tell you this. and then quote you $500 plus to repair. I can't even remember how much, I have decided it was not worth it.
Also this website could help you:
http://www.wjjeeps.com/seats/seats.htm

Oct 31, 2008 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
2005 Jeep Grand Cherokee Logo

Related Topics:

323 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...