Question about 1990 Ford Thunderbird

1 Answer

Can you start without a key by popping the ingnition

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 110 Answers

What do you mean popping the ignition

Posted on Jan 08, 2014

  • mike briner Jan 08, 2014

    what do you mean popping the ignition

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Key stuck in ingnition


If your battery goes dead, the ignition locks the key in ignition switch. You put a new battery in and you'll be able to remove the key
your anti theft system may be enabled. Did you play with the power door locks before starting
Under the ign lock assbly there is a small plastic plug... pop the plug out and stick a small screw driver in...u should imediately feel a spring load button in there. Push up with the screw driver and turn key back, it will come out.

Dec 24, 2011 | 2003 Chevrolet TrailBlazer

1 Answer

My key is stuck in the ingnition i found this little switch that is locking it in place,when i disconnect the switch my key comes out,can i leave that device disconnected?


Normally when a component of the ignition is disconnected it disables the steering. If the steering works and the car starts without it, it should be fine.

May 05, 2011 | 2008 Nissan Versa

1 Answer

Ilost my keys, and had to have my car so i broke the ingnition houseing...to try and crank it...but when i try turning it over it is telling me something about the anti teft system and i should remove the...


you def messed up it needs the ignition key to bypass the theft system. without it you cant start it. replace the housing install a new ignition key and tumbler and have reprogramed to solve this problem

Jan 19, 2011 | 1998 Cadillac DeVille

1 Answer

1996 toyota corolla I am replacing the ingnition


Is it possible to turn the key without braking it. In other words dont force it.

Nov 05, 2010 | 1996 Toyota Corolla

2 Answers

I have a 1993 buick lesabre. The security light is flashing and will not start. I checked the fuse it was ok. I tried our other key and still wouldn't start.


there may be a broken wire from the ignition swith going down the steering column,theres two sensors at the begining opening of switch, sometimes they get stuck and dont pop back out, in turn it doesnt touch the chip on the key and cant read it,take a look with a light use a small pic and push lightly on them and see if the y push in and pop out, if they do then replace ignition swith,theres a way to bypass,use an omh meter and measure resistance of key chip, then buy a resistor with the same value,and connenet to wires from switch under the dash,cut wires and put conecting the two going to switch with resistor connecting them together,heres a diagram,193b32f.jpg

May 06, 2010 | 1993 Buick LeSabre

1 Answer

The dealership cut a new key for my car (mine was taken from the gym by someone - probably by mistake) and told me that I would have to "reset" the car. The directions I was given took 30 minutes to...


you have to put the key in the ingnition and turn it to the on position (rite before the start possition) and walk away for about 20 min then go and start the car if this does not work then the key they cut isnt going to work for your car and thge whole ingnition switch will have to be switched out

Jan 14, 2010 | 2006 Chevrolet Impala

2 Answers

How do you check and replace the igintion?


loose battery connection, or loose wire, ground wire maybe.

Oct 22, 2009 | 1997 Chevrolet Lumina

1 Answer

Ingnition key will not turn to start the car 2002 astro van


I put oil on the key and put it in the ingnition, then moved the key till it moved,
then put a little more oil on the key.

Jul 16, 2008 | Chevrolet Astro Cars & Trucks

Not finding what you are looking for?
1990 Ford Thunderbird Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...