Question about 2010 Chrysler Town and Country

1 Answer

How do I remove the drivers door panel on a 2010 chrysler town and country

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Chrysler Expert
  • 473 Answers

Remove all screws from the inside door panel around the handle and anywhere else then gently take a flat screw driver and start prying the door panel away from the door but be careful not to break the plastic clips on the inside of the door panel

Posted on Dec 02, 2014

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
emissionwiz

Marvin

  • 85206 Answers

SOURCE: i have a problem with power sliding doors on 2001 Chrysler Town and Country limited

do you mean they are sticking?

Posted on Oct 20, 2008

motor1258

Mike Butler

  • 6674 Answers

SOURCE: The power lock (driver's side sliding door) on our

Take a look at end of door where latch is & post where the 2 meet when closed. Look for round metal button/contacts, about 1/2" in diameter. If you look close, they should line up to make contact with each other when door is closed. Take some fine steel wool (preferred) or fine sandpaper and scuff them up until you see metal is clean on both surfaces. Now try it, and let me know what happens.

Posted on Mar 09, 2009

keemo68

Ronald Mueller

  • 1263 Answers

SOURCE: radiator fan relay,2001 chrysler town country

the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays

Posted on May 08, 2009

its420_us

  • 316 Answers

SOURCE: chrysler town and country wiring diagram

2002 Chrysler Town and Country Car Stereo


Car Radio Battery Constant 12v+ Wire: Gray/Red
Car Radio Accessory Switched 12v+ Wire: Black/Pink
Car Radio Ground Wire: Strap or Chassis
Car Radio Illumination Wire: Orange/Tan
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: Gray/Green
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Green
Left Front Speaker Negative Wire (-): Green/Brown
Right Front Speaker Positive Wire (+): Gray
Right Front Speaker Negative Wire (-): Gray/Brown
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Green/Black
Left Rear Speaker Negative Wire (-): Green/Orange
Right Rear Speaker Positive Wire (+): Gray/Black
Right Rear Speaker Negative Wire (-): Gray/Pink

Posted on May 25, 2009

Spbharley

  • 79 Answers

SOURCE: power door locks on 2005 chrysler town and

There is an ecu flash for this repair. You may get the locks to start working again with a battery disconnect.

Posted on Jun 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

How to Install Replace Remove Front Door Panel Chrysler Town and Country 04-07...


How to Install Replace Remove Front Door Panel Chrysler Town and Country 04-07 1AAuto.com

on Apr 05, 2012 | 2007 Chrysler Town & Country LX New Cars

1 Answer

Where is the fuse for the power outlet on a 2010 Chrysler Town & Country


Fuse is under the dash drivers side Accessory fuse in panel
Mike

Apr 25, 2016 | 2010 Chrysler Town and Country

1 Answer

Removal of the front driverside door panel on a 2010 town and country


Look at "ask.com" some dodge panels have hidden screws at the bottom of the door panel in the carpet material

Oct 31, 2013 | 2010 Chrysler Town and Country

1 Answer

2004 chrysler town and country remove driver side oor panel


you will need to remove the screws that hold on the panel. One is located in the hand cup that you would pull on to shut the door, and I think if I recall correctly another one in the door open latch. The rest of the panel has plastic clips that hold it on there all the way around, just pull lightly on it, adjust your strength as needed to get it to "pop" out one clip at a time. Then you will also need to take note to not to fully remove the panel and disconnect your electric items such as your power window switches and speaker.

Oct 06, 2010 | 2004 Chrysler Town & Country

2 Answers

2008 Chrysler Town & Country. Need to remove inside passenger door panel to access wiring harness for replacing outside passenger side mirror. I removed the 2 torx screws on the door panel (one...


There are about 10 fasteners holding it in place. Check with your library to see if they offer online car repair manuals. If not, invest in a 1-year subscription to alldatadiy.com and print out the diagrams.

Sep 02, 2017 | 2008 Chrysler Town & Country

1 Answer

How do I remove the door panel to gain access to malfunctioning power window on drivers side on 2002 chrysler town and country van


Remove all the screws you can, I think there are 4-5. Then, there are plastic snaps all the way around the bottom. (buy new snaps before hand) Pull from the bottom, it will feel like you are breaking it, but its just the snaps. Disconnect the power window wires, mem seat wires, and the metal bar for the door latch. Be careful not to damage the wiring!

Dec 22, 2009 | 2002 Chrysler Town & Country

1 Answer

Power window does not work


you need to buy or make a clip removal tool. it looks like a sturdy 2 prong fork to pry off the plastic clips.this id whats holding the interior panel and some screws holding the door opener

May 30, 2009 | 2002 Chrysler Town & Country

1 Answer

How do I remove a drivers side mirror from a 2001 Chrysler Town & Country?


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Mar 19, 2009 | 2001 Chrysler Town & Country

Not finding what you are looking for?
2010 Chrysler Town and Country Logo

731 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...