Question about 2005 Dodge Neon

Open Question

Dodge neon 2005/2.0--change solenoid and both speed sensers.clear codes.still in 2 gear?dennis

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 512 Answers

SOURCE: Dodge Neon code 1494

p1494 isnt for the purge solenoid it is for a mechanical switch failure detected in the leak detection pump. as long as the pump has vacuum going to it the likely cause is the pump itself. it is attached to the vapor canister

Posted on Dec 26, 2008

Ad

Anonymous

  • 52 Answers

SOURCE: where is the shift solenoid located on a 2003 dodge neon sxt

the trans shift solenoid pack is bolted to the side of the trans closer to the radiator. it is rather large and there are three 10mm bolts holding it to the trans. it is under the input speed sensor and just under the spot where the cooler lines go into the trans.

Posted on Apr 11, 2009

Moe

  • 335 Answers

SOURCE: 2005 dodge neon codes p0731, p0700, p0573 and p0720

The codes listed all point to the transmission being in bad shape or some wiring got crossed. Check with a trans shop for an estimate.

Posted on Jul 18, 2009

SOURCE: i have a 2005 dodge neon, throwing codes p0129,

you will have to deal with the u code first. This is a communication problem between computers. My first guess is you have a bad computer or an open wire somewhere. Their is no way a backyard mechanic can do this without the proper tools to diagnose and with the knowledge to not cause further damage.

Posted on Nov 02, 2009

Anonymous

  • 34 Answers

SOURCE: I have a 2005 Dodge Neon and the engine light came

a had the same problem. i am 99.9 percent sure that the wires going to the sensors underneathe the battery box and air intake are broke inside the insulation. Get to where you can see the connectors. remove the tape from both sensor connectors and give the wires a pull each wire done seperately. Mine was an orange wire and a purple wire. It is not noticeable by looking at the wires because it is the copper wire inside the insulation that will be broke. Find the broke ones and splice in new wire and the problem will be fixed.

Posted on Jan 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wont shift gears


Dodge Neon Questions - 04 neon will not go into high gear ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusNov 3, 2012 - 04 neon will not go into high gear - 04 neon won't go into high gear. changed transmission fluid. (it tried to change after fluid was changed) gas cap ... ... Car: 2003 Dodge Neon SXT, automatic transmission. As of today, I have ...

Dodge Neon Questions - 2005 Dodge neon does not shift ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusApr 6, 2014 - Your cars computer gathers info on speed in order to shift gears properly.... then you won't have a speedo and the ECM will not tell the TCM to shift gears in the trans. .... Car: 2003 Dodge Neon SXT, automatic transmission.

Neon wont shift out of first gear auto. - DodgeTalk : Dodge Car ...

www.dodgetalk.com > ... > Dodge Neon - General Talk
Jul 30, 2011 - I have a 2003 dodge neon se and it will run and drive. The transmissonwill not shift out of first gear. Where do I start? Compare to Toyota Tundra. Get Tundra on ... 2000 Stratus won't shift out of First Gear
Mar 14, 2007
Not shifting out of Second Gear???
Jan 15, 2007
46RE wont shift out of first at full throttle.
Nov 17, 2006
Transmission wont shift
Nov 3, 2005
More results from www.dodgetalk.com

Jan 06, 2016 | 2003 Dodge Neon

3 Answers

Got 2005 dodge neon 2.0 engine code 700 and 732 what does this mean


700=TRANSMISSION CONTROL SYSTEM, NEED TO READ TRANSMISSION DTC's ON THE DRBIII(R)
732= TRANSMISSION.....POSSIBLE CAUSES----RELATED DTC'S PRESENT, TRANSMISSION SOLENOID/PRESSURE SWITCH ASSEMBLY, INTERNAL TRANSMISSION, INTERMITTENT GEAR RATIO ERRORS..
Hope this helps ??

Jul 02, 2011 | 2005 Dodge Neon

1 Answer

2005 dodge neon the gas guage is going crazy,the check engine light is on,speedometer wont work,transmission wont shift out of first. showing a p0700 code.i replaced inflow,outflow sensors and solenoid but...


Hi, where to start: get a scan of your OBD2 connector at your local parts chain. Write down the trouble code and send to us. It will probably be something about the vehicle speed sensor, but please send us the exact code, starting with a "P" and followed by 4 digits. There may be additional codes. The fuel gage may or may not be related--did this all happen at the same time?

Apr 18, 2011 | 2005 Dodge Neon

2 Answers

2.0 dodge neon. stuck n second gear.


these transmissions are notorious for being "junk" replace transmission.

Apr 13, 2010 | 2005 Dodge Neon

1 Answer

My 2005 neon failed emissions. It gave me a codes 0441. What excatly does that define?


Trouble Code: P0441 (2.0L L4 VIN C Auto)
EVAP Purge Flow Monitor Fault Print this code dataprint_icon_codes.gif Number of Trips to Set Code: 2
OBD II Monitor Type: CCM Details
Indicators: MIL Details
Trouble Code Conditions:
Engine at idle speed in closed loop for 200 seconds, BARO Sensor signal less than 8,000 feet, ECT Sensor more than 160ºF, no Low Fuel, MAP Sensor signal less than 23.7" Hg, and the PCM did not detect any purge flow through the EVAP system during this test.

Possible Causes:
  • EVAP purge solenoid vacuum line loose, leaking or restricted
  • EVAP purge solenoid stuck leaking, stuck open or stuck closed
  • EVAP purge vacuum line to canister leaking or disconnected
  • EVAP canister leaking, damaged or has failed

2005 Dodge Neon - All Configurations - P0441

Nov 01, 2009 | 2005 Dodge Neon

1 Answer

2005 Dodge Neon SXT error code P0700


you have a output speed sensor going out probley the tranny is in lemp mode and is stuck in 2nd gear

Jul 24, 2009 | 2005 Dodge Caravan

1 Answer

2005 dodge neon codes p0731, p0700, p0573 and p0720


The codes listed all point to the transmission being in bad shape or some wiring got crossed. Check with a trans shop for an estimate.

Jul 18, 2009 | Dodge Neon Cars & Trucks

1 Answer

Where is the shift solenoid located on a 2003 dodge neon sxt


the trans shift solenoid pack is bolted to the side of the trans closer to the radiator. it is rather large and there are three 10mm bolts holding it to the trans. it is under the input speed sensor and just under the spot where the cooler lines go into the trans.

Apr 11, 2009 | 2003 Dodge Neon

1 Answer

02 Neon won't shift out of second gear in Drive


Sounds like the valve body is loose, warped or blown

Apr 07, 2009 | 2002 Dodge Neon

2 Answers

Dodge neon shifting problems


Sean Pried it could be your A604 4 Speed Automatic Transmission Shift Solenoid which is located just in front of your transmission dip stick.

Aug 22, 2008 | 2005 Dodge Neon

Not finding what you are looking for?
2005 Dodge Neon Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...