Question about Cars & Trucks

1 Answer

G6 madza motor what are the settings for the distribtor to go back in

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 1,149 Answers

Not to worry friend, when my machine go sick i avoided going to mechanic looking for DIY_Repair when I found this website https://big-manuals.com/ and this book helped me repair it within an hour, all by myself!!!
From wiring diagrams, schematic illustrations, spark plugs info, parts info, chassis number, valve time settings, step wise instructions, torque specs, error/fault codes, engine info, to every single minute parts, you get everything in there you can't imagine how detailed it is

Posted on Dec 10, 2018

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Pontiac g6 power steering


Need to have the electric power steering module scanned to see what codes it has set. Could be a module issue or motor issue. Do you still have assist or is it very hard to turn the steering wheel?

Apr 04, 2014 | 2006 Pontiac G6

1 Answer

How to replace a blower motor on a 2006 G6


For this replacement procedure,click this link below :---How to replace blower motor and blower motor resistor on Pontiac G6?http://technoanswers.blogspot.in/2012/02/how-to-replace-blower-motor-and-blower.html
---------Also more help solutions recommended.Click the link below :---Blower motor replacing for all vehicles?http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html----------This will help.Thanks.

Feb 01, 2012 | 2006 Pontiac G6

1 Answer

How do I expose the motor on a 2006 pontiac g6 to


Remove everything from the headliner and remove all of the trim holding it in place. Carefully pry the headliner out from one side and the rest will now be easily removed. Unless the car has been subject to abuse and intense heat the headliner will not come loose from the backing and can be reinstalled.

Mar 27, 2010 | 2006 Pontiac G6

1 Answer

I changed coil in 1995 toyota 2.2engine camry .I had to remove distribtor in replacing coil . When I stared the car after replacing distribtor the car ran rough as if timming was off.


try to center the distributor on the lock down bolt if that doesnt work there is a diagnostic connector on the engine harness its either black or gray jump te and e1 to set the base timing at 10 on the crank

Feb 27, 2010 | 1995 Toyota Camry

2 Answers

G6 GT2007 Blower fan does not work at all. All


check relay HVAC relay.if all is good.blower motor is bad or HVAC control switch is bad.

Nov 22, 2009 | 2007 Pontiac G6 GT Convertible

2 Answers

There is a clicking sound that emanates from the driver side of my '05 Pontiac G6. It sounds similar to the sound an ignitor on a gas grill makes, only constantly. The noise goes away immediately when I...


clunking noise front when turning left and does it right also but not as bad 2006 g6 at low speed and goes away as you speed up but always there i have replaced lower control arms both side still there

Nov 18, 2009 | 2006 Pontiac G6

1 Answer

My1999 madza 626 idles rough when its in drive or when i cut on


this could be a case of carbon debris in the throttle body plates and idle air control chambers...simply might just need serviced/cleaned...pull air intake off throttle body and spray with a good throttle body cleaner spray including the idle air ports. Ive also seen motor mounts cause this as this is more of a vibration felt in gear

Jun 28, 2009 | 1999 Mazda 626

1 Answer

Readiness monitor codes for a 1997 mazda protege 1.5 dohc


i got a 1997 madza protege 1.5L and i was wondering if i could fit a 2003 madza 3 2.0L engine into it cuz i need more power can someone answer this for me plz asap???

Aug 01, 2008 | 1997 Mazda Protege

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...