Question about 2006 Dodge Grand Caravan
I really don't know the answer to your question but you can turn it on and test all fuses to find which is blown. Or, what I did was to place the '2006 dodge grand caravan fuse diagram' in your search box and press the search and look down the list to find which is yours. That's how I got the full diagram for my '99 ranger just to find which fuse powered the speakers so I could put a switch on it. It always drained the battery and this switch on that fuse worked. No more battery drain.
Posted on Jan 12, 2019
Testimonial: "My problem is not the location! It shows on the lid of the fuse compartment! My problem is that there is no contact pins in the holes where you put the fuse!"
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I replaced the EGR Valve ($80 after tax), problem solved, vanruns great now. Now my problem is that I can't get the light to turn off.
Posted on Oct 06, 2008
JUST COMPLETED THIS JOB TODAY. MAKE SURE THE ENGINE HAS COOLED DOWN . IT TOOK APPROX 2 1/2 HRS. DISCONNECT THE NEGATIVE POST ON THE BATTERY. JACK UP PASSENGER SIDE FRONT AND SUPPORT ON JACK STANDS. REMOVE PASS. FROUNT TIRE. DRAIN RADIATOR INTO CONTAINER FOR PROPER DISPOSAL OR REUSE. USING FLOOR JACK PROVIDE SLIGHT TENSION ON OIL PAN WITH A SHORT 2 X 4 WOOD PIECE TO PROTECT OIL PAN. LOOSEN 3 ENGINE MOUNT BOLTS ON PASS. SIDE OF ENGINE COMPARTMENT. ALLOW APPROX 1" BETWEEN SHOULDER OF BOLTS AND MOUNT. LOWER ENGINE UNTILL BOLTS ARE SET ONTO MOUNT. REMOVE ENGINE SPLASH SHIELD INSIDE WHEEL WELL OF REMOVED TIRE. LOCATE WATER PUMP AND LOOSEN 3 PULLEY MOUNTING BOLTS (THIS IS WHILE BELT IS ON PULLEY) REMOVE SURPENTINE BELT AND CONTINUE TO FULLY REMOVE THE PUMP PULLEY. IT WONT COME OUT AS THE PUMP & PULLEY HAVE TO COME OUT TOGEATHER. REMOVE 5 WATER PUMP BOLTS AND CAREFULLY WORK WATER PUMP OUT BETWEEN THE ENGINE AND VEHICLE FRAME. CLEAN ALL MATING/GASKET SURFACES AND BOLTS. USING A SMALL AMOUNT OF TACKY SEALENT TO INSURE THE NEW WATER PUMP SEAL STAYS IN PLACE, THE INSTALL IS PRITTY MUCH THE REVERSAL OF REMOVAL.
GOOD LUCK, REMEMBER TO TIGHTEN ALL BOLTS TO MFR SPECS AND BLEED THE AIR OUT OF THE COOLANT AS REQUIRED.
Posted on Apr 29, 2009
You cannot clean them purchase a new one and pull the old one out of the valve cover, and disconnect the hose that runs to it. install the hose on to the new egr with a new worm clamp and push the other end into the valve cover. should take about 10 minutes.
Posted on Sep 12, 2009
You can get free owners manuals online at:
or just type "owners manuals" in your search.
Here is a post I found that worked for my 2005 caravan.
For a 2001 Dodge Caravan: The owner's manual is vague, only stating that all fuses are under the hood in the fuse box, no diagrams. Once you have removed the fusebox cover, the diagrams for what each fuse does is provided under the lid. UNCLEARLY marked is the radio fuse, a 20amp fuse located 2nd row from top to the right of the accessory relay. It is marked: RDO/IP IGN.
Posted on Sep 19, 2009
The fuse box is located under the hood. There is component map printed on the inside of the cover. This tells you on your model where the fuse or relay is located
Posted on Jan 19, 2010
Tips for a great answer:
Feb 12, 2015 | 2006 Dodge Grand Caravan
Dec 18, 2014 | 2003 Dodge Grand Caravan AWD
Oct 26, 2012 | 2002 Dodge Grand Caravan
Jun 07, 2012 | 2006 Dodge Caravan
Feb 10, 2011 | 2006 Dodge Grand Caravan
May 17, 2010 | 2006 Dodge Grand Caravan
Jan 10, 2010 | 2006 Dodge Grand Caravan
Dec 29, 2009 | 2006 Dodge Grand Caravan
Oct 21, 2009 | 2006 Dodge Grand Caravan
Jun 23, 2017 | 2006 Dodge Grand Caravan
45 people viewed this question
Usually answered in minutes!