Question about 2007 Hyundai Santa Fe

2 Answers

My 2007 Santa Fe is locking up , feels like from the back end, a nasty grinding noise, then it kicks up. Al the brakes are good and new, any help would be appreciated.

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

  • Hyundai Expert
  • 146 Answers

First is this a awd vehicle ? If so the rear coupler on rear diff is locking up and has a solenoid that controls lock up . It may need whole coupler unit to correct issue which is common or normal to perform , Hyundai has service bulletins on this condition IF it is AWD !

Posted on Jan 14, 2019

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

  • Expert
  • 66 Answers

It sounds like a bad bearing. Either a wheel bearing or differential bearing if it is all wheel drive.

Posted on Jan 14, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

angelo63
  • 129 Answers

SOURCE: 95 ford explorer, grinding noise/vibration at slow speeds.

CHECK YOUR UNIVERSAILS COULD BE WORN OR DRY U NEED TO PULL OUT THE SHAFT TO CHECK PROPLEY CHECK FOR STIFFNESS AND NOTCHEY MOVEMENT

Posted on Dec 16, 2008

jmgldsmth
  • 2005 Answers

SOURCE: 2007 Hyundai Santa Fe Headlight

you need a torx screwdriver

Posted on May 29, 2009

  • 148 Answers

SOURCE: 2003 Hyundai Santa Fe ABS light is on along with TCS light

you may have damaged the ABS sensor or wire to the sensor up front check the wire that runs from the inner finder well and make sure it connected to the ABS sensor on the spindle

Posted on Jul 15, 2009

  • 135 Answers

SOURCE: 2002 Hyundai Santa Fe = ABS, TCS lights come on.

Probably bad wheel bearing

Posted on Aug 05, 2009

  • 204 Answers

SOURCE: rhythmic grinding noise front end - 98 chevy astro AWD

Could be low on oil, trans doesnt have fluid, wheel bearings are gone, or could be something stuck under the vehicle and either the tires or the drive axle is rubbing against it.

Posted on Feb 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Noise coming from one wheel - sort of a grinding noise but not consistemt


Can be three things

worn wheel bearings

stone in the brakes (most likely)

worn or incorrectly fitted pads

Jack the car up, spin and look.

Jul 10, 2016 | 2004 Hyundai Santa Fe

1 Answer

Loud rear whine, not brakes new ones fitted


Was noise there prior to brake replacement? If so, possible wheel bearing noise. Noise should get louder the faster the wheel rotates with a bearing problem.

Feb 22, 2016 | 2007 Hyundai Santa Fe Limited

1 Answer

2004 Hyundai Santa Fe? squeaky noise frnt driver side wheel


I do think the same way. If the pads look flat and not so worn have the rotor turned to eliminate the squeaksyou are encountering

May 31, 2010 | 2004 Hyundai Santa Fe

1 Answer

Grinding noise from front right. rotors seem okay and I can turn the rotor with ease. Is it the wheel bearing?


Does it happen all the time or when brakes are applied? Usally a bad bearing will cause a growling noise. I would check both the brake pads on the right side. Often the inner pad will wear off, then you have metal against metal, causing a grinding noise.

Mar 10, 2010 | 2002 Hyundai Santa Fe

1 Answer

Veh seems to have trans or at least emer brake problem ..after veh stopped. wouldnt move again...engine revved fine..had trouble even pushing to side..seemed wheels were locked.noticed a whistling noise...


dear friend-yes you are right your problem is brake related,one of the calipers must have seized,it will be best if you strip all four clean and lubricate al the pins.

Nov 06, 2009 | 2001 Hyundai Santa Fe

1 Answer

Sporadic shriking noise when in motion at lower


Either a brake pad or the fan belts !
Lube the fan belts with candel wax or silicone spray, if the same noise, it is a brake pad !!

Aug 16, 2009 | 2007 Hyundai Santa Fe Limited

4 Answers

Grinding noise between 0mph and 10mph


Had a very similar symptom on my 2005 Hyundai Santa Fe and I made a video of how I diagnosed and fixed the problem.

Feb 03, 2009 | 2004 Hyundai Santa Fe

2 Answers

Brakes locked up ran through stop sign 04 santa fe


it sounds to mee like the brake power booster or abs is acting up.if you dont feel safe driving it use it as a trade in for another vehicle that you feel more comfortable with

Jan 27, 2009 | 2007 Hyundai Santa Fe Limited

1 Answer

Power locks with a mind of their own!


Sounds like a wiring/switch issue. I would have your dealer take a look at it to see if there are any problems with any of the switches, or the wiring.

Jun 11, 2008 | 2007 Hyundai Santa Fe Limited

Not finding what you are looking for?
2007 Hyundai Santa Fe Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

83850 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22413 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...