Question about 2005 Chrysler PT Cruiser

2 Answers

How much freon do i put in a 2005 pt cruiser

2.5 L engine w/ turbo

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,117 Answers

I'd go with, enough to get the suction line cold, anticipate about 30 oz total from vaccuum point. No more freon, try furane.

Posted on May 16, 2019

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 31,012 Answers

It doesnt use freon. more likely r 134 and no i dont know how much because i dont know how much is in there now. if you drained the system youll need to pull a vacuum on it before any coolant is added

Posted on May 16, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

66 chrgr
  • 1011 Answers

SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?

the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?

Posted on Jan 25, 2009

rockitman187
  • 2559 Answers

SOURCE: 2004 chrysler pt cruiser starter motor removal

You may sneak it out with small fingers with out pulling out the starter.

If starter removal is required,Just unhook the battery cables,Remove the 2 bolts holding the starter on.


Please rate this a fixya

Posted on Feb 08, 2009

  • 323 Answers

SOURCE: 2005 pt cruiser check engine light came on

P0457 is a loose gas cap, P0456 is a small evap system leak. The seal on your gas cap is probably worn. Replace the cap, clear the codes with either a diagnostic tester or by disconnecting the battery for a few minutes and reconnecting it. It will take a few days for the code to come back if it isn't fixed, but that usually does the trick. I hope this helps.

Posted on Apr 27, 2009

66 chrgr
  • 1011 Answers

SOURCE: 2005 pt cruiser misfire low rpm

Have your plugs and wires checked for replacement:)

Posted on Jul 31, 2009

  • 1 Answer

SOURCE: 2005 Pt Cruiser idles rough at stop lights/ poor gas mileage.

i hav a 2003 pt cruiser 2.2 crd touring it wont go over 3000 revs engine light cums on. error code p0243 i hav replaced wastegate solenoids cleaned egr valve cud it be the mass air flow sensor that has a problem thanx

Posted on Jun 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is code p0234 on my chysl pt cruiser


P0234 is over boost detected.Trouble code P0234 indicates the power train control module senses a dangerously high boost pressure from the engine's forced induction system. Levels of boost over recommended levels can harm engine.
press the helpful button and check links below

OVERBOOST Code P0234 from OBDII Turbo Dodge Forums Turbo Dodge Forum for...

PT Cruiser Forum

P0234 Turbocharger Supercharger Overboost Condition Code

http://www.datsc.com/tabid/122/OBD-Error-Code/P0234/Diagnostics/chrysler/Default.aspx

Feb 03, 2016 | Cars & Trucks

1 Answer

How do i change the turbo motor and put a non turbo motor in a 2003 pt cruiser


Changing out an entire engine is no easy feat. The biggest difference you'll have is with the exhaust system. The non turbo engine connects differently.

Oct 01, 2014 | 2003 Chrysler PT Cruiser

1 Answer

2005 chrysler pt non turbo p0031 p0037 changed asd relay still engine light on


Disconnect your battery and then reconnect it will reset It work for is

Mar 22, 2014 | 2005 Chrysler PT Cruiser

1 Answer

Check Engine light on and off - P0031 and P0037


the sensor heater circuits have to be diagnosed; you probably didn't need to replace them.

Mar 14, 2013 | 2005 Chrysler PT Cruiser

1 Answer

Blown turbo 2005 Chrysler PT Cruiser


indicates a turbo failure
remove it and have it overhauled/inspected

Oct 18, 2017 | 2005 Chrysler PT Cruiser

2 Answers

Where is crank sensor on 2005 PT Cruiser? It absolutely is not above the oil filter as on 01-03 PT's.


REMOVAL - 2.0, 2.4, 2.4L TURBO
The Crankshaft Position Sensor is in the front of the engine block just under the starter motor (CRANKSHAFT POSITION SENSOR LOCATION).

Disconnect the negative battery cable.
Raise vehicle and support.
On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
Remove the Structural Collar (Structural Collar and Bending Strut-(Automatic Transaxle Equipped) ), refer to the Engine, Structural Collar Removal and Installation section.
Unlock and disconnect the electrical connector to the crankshaft position sensor.
Remove the crankshaft position sensor bolt.
Remove the sensor. Arrow points to sensor in picture.


emissionwiz_108.gif

Aug 22, 2011 | 2005 Chrysler PT Cruiser

1 Answer

Problem with 2005 pt turbo


your turbo is making a banging noise its more then likely pooched

Aug 23, 2017 | 2005 Chrysler PT Cruiser

1 Answer

2005 Convertible PT Criser, Turbo


Emission devices in vehicles sold in the US are covered for 8 years. This is federal law. Talk to the service manager at your local dealer. A misfire will cause emissions to go up so it should be covered.

Mar 05, 2010 | 2005 Chrysler PT Cruiser

1 Answer

How do i replace the liquid line and drier on a 2004 pt cruiser 2.4L turbo engine.


first you must recover the freon from the system then change the line always installing new orings, evacuate the system "which means to put it into a vacuum to remove all the air and moisture out of the system" then recharge and enjoy....on your turbo pt it calls for .3 for the job ...anyone should be able to do it in like 30-40 min. proved you have the right tools...recovery machine and so on.....

Sep 19, 2009 | 2004 Chrysler PT Cruiser

1 Answer

2005 PT Cruiser leak anti-freeze leak????


the overflow bottle probobly has a crack in the seam of the bottle.you can replace the bottle or remove it and use some epoxy to repair it.

Jul 29, 2009 | 2004 Chrysler PT Cruiser

Not finding what you are looking for?
2005 Chrysler PT Cruiser Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...