Question about 2005 Dodge Dakota
There are probably people who steel them that could help you but I truly think you are out of luck with this one. You are likely going to have to get one programmed by the dealer.
Posted on Jul 12, 2019
Sorry to say it but you are out of luck in this case. call a good locksmith and save money
Posted on Jul 12, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
the way that i was told how to do a quick fix for is to hold the key in the electrical start and the actual start up of the engine and hold it there tell the security light is solid and then turn off the truck then bring it back to that point and let it blink until it turns off then you can start the truck.
Posted on Sep 24, 2008
SOURCE: security system how do i bypass
if you want a quick way to fix it run a wire from your starter in to the car another from the battery into the car and get a start button its quick easy i had the same problem.
Posted on Nov 03, 2008
To change the sparks on a 2005 4.7L Dodge Dakota you will need the following:
Note you will have to remove the air intake located at the top of the engine, and will have to move some of the coolant lines out of the way.
At the top of the engine there are 4 sparks on each side. The coils are held in place with a 10mm bolt. Undo the 10mm bolt and unclip the coil. Next pull out the coil.
Insert the socket, with extension into the spark plug hole.
Remove spark plug.
Check the gap on new spark plug, it should match stock.
tighten to approximately 25ft.lbs. (check spark-plug packaging for exact torque requirements).
repeat this process with all other sparks.
be sure that no dirt gets into the spark plug holes.
Posted on May 11, 2009
No i do not think you have electrical problem, try this.
Car in Park
push and hold unlock on good remote for 5 to 10 seconds
while holding unlock, press and hold panic, then release together
Listen for chime
press and release any button on all remote to be programmed.
If this will not work you need to bring the Vin# and remote to a dealer for reprogramming.
Posted on Aug 09, 2009
Tips for a great answer:
Sep 15, 2015 | Dodge Cars & Trucks
Jul 19, 2015 | Dodge Cars & Trucks
Jun 29, 2015 | 2001 Dodge Dakota
Mar 13, 2015 | 2005 Dodge Caravan
Nov 10, 2010 | 2005 Dodge Dakota
May 18, 2010 | 2005 Dodge Grand Caravan
Mar 11, 2009 | 1996 Dodge Dakota
16 people viewed this question
Usually answered in minutes!