Question about Acura Cars & Trucks
The service and repair manual with diagram will provide you step by step help to locate and fix the problem easily and you will get the manual from the given link https://toolsnyou.com
Posted on Aug 19, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: remote garage door opener
1. Position vehicle within 10 feet of garage door- engine off and battery on.
2. Press/hold 2 outside buttons of Homelink transceiver until red indicator starts flashing rapidly, then release button. This should take about 20 seconds. This erases any previously learned codes.
3. Press/hold remote control and press/hold button of Homelink transceiver simultaneously. Slowly move remote control from 5" away to 1" away from Homelink transceiver. Release both buttons after red indicator starts blinking rapidly. This should take about 5 seconds. I discovered that the Homelink in my TL is a bit faulty because it took much longer to accomplish this than when programming the Homelink in my MDX. My TL's Homelink may "unlearn" it's code in the future and the needed proximity of the TL to the garage door may be much closer than desired until I get the Homelink fixed.
4. Press training button on garage door opener unit until the indicator lights illuminates- this should be immediate.
5. Within 30 seconds press/hold the Homelink button for 2-3 seconds until the red indicator starts flashing rapidly. Repeat a second time. It should now be programmed. Check it by pressing the programmed button on the Homelink receiver.
6. When programming more than 1 garage door opener unit, disconnect power from unit before programming more units. By not doing this the programmed unit could conflict with the unprogrammed units commands.
1. The Battery in the garage door remote may be too weak to program Homelink. However, the battery may be strong enough to operate the garage door. One of my remote controls had a weak battery- my system was installed today, fresh out of the box. I had to use the second remote control for the programming of Homelink on my 2 vehicles.
2. Antenna on the garage door opener unit must be hanging down, fully extended.
Posted on Dec 08, 2008
check the bulkhead area under the wipers. the scuttle panel has a drain hole & tube that ducts rain water away but can become blocked by dirt and leaves etc, then the water builds up and flows backwards over the edge and down the back of the dashboard via the bulkhead joints. A knitting needle or welding rod can be used to poke the hole clear then test by pouring a small amount of water through the grille beside the wipers and ensure it runs away and does not sit.
Also check your coolant level, if it is down then the leak may be from the heater matrix inside the car, this is more difficult to fix and needs the dashboard removed in a lot of cars.
The 3rd possibility is a leaking windscreen surround. Silicone would fix that, get the black stuff and put a thin bead around the outer edge of the windscreen rubber and smooth neatly with a wet finger or cloth.
Posted on Oct 24, 2009
the steering angle sensor is used as one of many inputs on honda's vehicle stability assist system. so in short yes. hope this helps
Posted on Jan 27, 2010
Tips for a great answer:
Nov 09, 2014 | 2003 Acura MDX
Oct 07, 2013 | 2003 Acura MDX
Apr 19, 2012 | 2003 Acura MDX
Oct 14, 2010 | 2007 Acura MDX
Apr 28, 2010 | 2004 Acura MDX
Dec 15, 2009 | 2003 Acura MDX
Aug 18, 2009 | 2003 Acura MDX
Aug 05, 2009 | 2003 Acura MDX
Jul 09, 2009 | 2003 Acura MDX
21 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: