Question about 2005 Jeep Grand Cherokee

1 Answer

Replace broken mirror on motorized, heated side view mirror

Replace mirror on motorized, heated side view mirror -old mirror is off and housing seems to be ok. Have a replacement mirrror (used), but I do not know how to line it up--does it just have to be pushed hard? Does motorized element have to be lined up a certain way in order to push on replacement? Thanks!

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 1,234 Answers

I believe this is what you are looking for hope this helps.
http://www.wjjeeps.com/mirrors2.htm
i could explain it but this is better cuz you may want to print it out.
Happy New Year

Posted on Jan 02, 2018

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 76 Answers

SOURCE: How to replace the Passenger side Rear View Mirror on door.

there should be a plastic cover on the inside of the car where the mirror is take this off and there will be a connector block unplug this and there should be screws undo them and the whole thing should come off themn and you should be able to seperate them then.

Posted on Jul 30, 2008

Mikey108
  • 475 Answers

SOURCE: Replacing a drivers side mirror

There is a panel on the inside of the door where the mirror is.
That has to come off.
In some cases the door panel has to come off also.
Under the mirror panel there are nuts that hold the mirror on. Remove the nuts unplug the harness and install the new one.

Posted on Oct 07, 2008

Mikey108
  • 475 Answers

SOURCE: Side view mirror

Something broke inside the mirror.
Replace it.

Posted on Oct 23, 2008

  • 290 Answers

SOURCE: my rear view mirror fell off in my 2003 Honda Element.

auto parts stores sell an adhesive to glue the metal mount tab back to the glass.

Posted on Apr 01, 2009

  • 1348 Answers

SOURCE: Side view mirrors

get a wiring diagaram and check it.
the switch that controls which mirror you want to control could be stuck in the middle,or inoperative

Posted on May 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace side mirror[ mirror only],ford focus,driver side, 2013 model


If the mirror housing is in place, Have one cut to fit. Glue it in. If the housing is broken, replace all of it. You can't fix a broken side mirror. Tried to many times.

Oct 08, 2016 | Cars & Trucks

2 Answers

How to replace outside side power mirrors in original housing? 2008 Ford Edge


Google replacement mirror glass for Ford Edge 08.

They make a replacement mirror glass available that uses double sticky tape. This has worked great for me. The heated function still continued to work!! In my case I replaced a scratched mirror leaving the old mirror in place. If yours is broken included is a link for a procedure to replace a broken mirror.

Confirm the dimensions before purchasing. Some car manufactures have more than one design for different model cars same year..

26182860-kzssal3k2qlm4jsc53ab1s2h-2-0.jpg This is an easy repair.
How to Repair and Replace Broken Side Mirror Glass DIY

May 02, 2016 | 2008 Ford Edge SEL

1 Answer

How do I replace a broken side view mirror, drivers side. Only the mirror itself is broken, so is it necessary to replace the housing which is in perfect condition and where is the best place to purchase...


Go to your local auto parts store, they should be able to order just the mirror glass. Its held on with double sided tape and a little glue, you will have to scrape the old glass off with a flat screwdriver or similar.

Apr 05, 2010 | 1999 Chevrolet Cavalier

1 Answer

2004 GMC Sierra 2500 HD. Drivers side mirror was


You should be able to replace the glass, but I believe it is glued in place. You should be able to tell as you remove the old pieces. It is a special white glue.
I was able to get a great price for the whole mirror on ebay. even the ones with signals and heated.

Hope this helps

Jan 09, 2010 | 2008 GMC Sierra 2500HD 2WD

1 Answer

Passenger side mirroe is broken from the neck...


is it just the glass that broke?

Exterior Mirror Glass Removal
  1. Position the inner edge or the exterior rear view mirror glass to its maximum travel.
  1. s1h~us~en~file=ani_caut.gif~gen~ref.gif WARNING: Place a shop towel between the exterior rear view mirror glass and the hand to avoid personal injury in the instance of glass breakage.
    Grasp the outboard edge of the exterior rear view mirror glass and pull outward.
  1. Remove the exterior rear view mirror glass.
    • If equipped, disconnect the heated rear view mirror glass electrical connectors.
Installation
  1. If equipped, connect the heated rear view mirror glass electrical connectors.
  1. NOTE: An audible click will be heard during installation.
    Press firmly in the center of the exterior rear view mirror glass until it snaps onto the exterior rear view mirror motor.

Jul 01, 2009 | 2001 Ford Taurus

2 Answers

Broken driver side view mirror-2005 camry


Heated mirrors usually have a symbol on them -- a small diagram showing squigley heat lines.

If you don't see this, it's probably not heated. But when you take the mirror off, if it's heated it'll have wires connected to the back.

Yes, you can replace a heated mirror with non-heated -- just leave the wires tucked out of the way when you install the new mirror.

Apr 29, 2009 | 2004 Toyota Camry

2 Answers

Instructions for replacement of side view mirror


the door panel near the mirror must be removed if not the entire door panel inside u will find 3 nuts to remove to get the old mirror off. hope this helps please rate me

Jan 12, 2009 | Pontiac Grand Prix Cars & Trucks

2 Answers

How do i remove and replace the driver's side mirror?


If the metal pivot arm is not broken you can just replace the glass and plastic housing. To remove the glass you tilt the glass down towards the floor and use a wide plastic or wood bladed object to prise from behind, the glass should pop off from its clips. Remember to catch it if its not damaged. To remove the housing once the glass is out you need to look underneath the mirror unit, there you will find a small plastic bung, gently prise it out and then use a long small flat bladed screwdriver straight up inside the hole and lever towards the front of the car whilst lifting straight up on the plastic housing, this should then lift off. To replace just slot the new housing on and click into place then fit the glass back, remember to connect the wires first if it is a heated glass.
If the metal pivot arm is broken then you will find the remaining screws behind the plastic trim inside the vehicle.

Oct 26, 2008 | 1998 Volkswagen Beetle

1 Answer

Side Mirrors will adjust side to side but not up and down.


There are two tiny motors in each mirror. one for up/down. One for side to side. They have jack screws (plastic) that fit into the motors.

You can manually put your hands on either side of the mirror and force adjust it. If you hear a ratcheting sound, the jack screws are OK. Then repeat with hands on top and bottom.

If you hear ratcheting and mirror stays where you stop it, that means one of the motors is bad. The motor assembly is available as a separate part.

-------------------------------------------------------------------------------------
Mirror Motor—Crown Victoria, Grand Marquis
Removal and Installation
  1. Disconnect battery ground cable. Refer to Section 14-01 .
  1. Remove outside Rear View Mirror Glass as outlined.
  1. Remove Outside Rear View Mirror as outlined.
  1. Remove two screws from outside rear view mirror motor.
  1. Remove outside rear view mirror housing from outside rear view mirror base.
  1. Disconnect connector and remove outside rear view mirror motor from mirror housing.
  1. To install, reverse Removal procedure.
1a865db.gif
Might be cheaper to buy used irror at car-part.com. Look for * to find page with cheapest part. Or, EBay. Good luck

Aug 11, 2008 | 1996 Ford Crown Victoria

1 Answer

How to replace the Passenger side Rear View Mirror on door.


there should be a plastic cover on the inside of the car where the mirror is take this off and there will be a connector block unplug this and there should be screws undo them and the whole thing should come off themn and you should be able to seperate them then.

Jul 13, 2008 | 1999 Pontiac Grand Am GT

Not finding what you are looking for?
2005 Jeep Grand Cherokee Logo

Related Topics:

279 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...