Question about 2000 Ford Taurus
I have a 2000 Mercury Sable my a/c is blowing hot air when on ac Max or set to 60 I have replaced the Blend Door Actuator motor i have check all the fuses i have disconnected and reconnected the battery when I cycle the temperature from high to low I do not see the blend motor moving
Posted by Anonymous on
If the blend door isn't moving then you've got a wiring harness or control head issue.,
Posted on Jan 25, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Sounds like your temperature actuator is not moving or your temp door is broken. On max a-c ,coolant is shut off to your heater core allowing only cold air in.
Posted on Jan 26, 2009
Check all the air hose up to that point look to see if all hose is intack and put to gether right look for holes and cloges
Posted on Oct 06, 2009
I recently did mine, I hear you can do it without taking the entire dash apart but I had no luck with it myself. I have to get ready for work but, on mine it was located down and to the left of the radio. its a white box...are you hearing a clicking noise or something? I had to roll the entire dash back and it was still a major pain getting it out.
Posted on Dec 07, 2009
You hot air comes from the water circulated through the heater core. It is like a miniture radiator with water flowing thru it constantly. So by opening the "Blend Door" you are permitting so much of this hot air to pass thru.
Seems like for some reason your heater core is plugged up. Just like a radiator can be. So water may be passing through your heater core but not passing through fully. Your heater core gets hot from water passing throught it from the engine. Then your doors open up, in proportion to how much air is permitted to pass over the heater core.
Suggest to remove the heater core and replace it. Seems the blend doors are working properly but again, if you have a non working heater core then no air can pass over the "Hot Core" for you to recieve hot air.
If you are not mechanically inclined, then go to a local parts store and you can buy a car manual, such as Chilton's or Hane's Car manuals, for your year and make to show you how to replace it. Then you can also have it for any other problems that may arise.
Posted on Jan 24, 2010
that clicking noise you hear is likely a relay in the fuse panel that needs to be replaced. the easiest way to find out which relay it is would be to put you finger on each relay as you actuate the device not working. once you locate the clicking relay replace it . to reset the computer just unhook the battery for about ten minutes. if you have an anti theft radio make sure you know the code for it and how to enter it before you unhook the battery.
Posted on Nov 27, 2010
Tips for a great answer:
Aug 04, 2013 | Mercury Sable Cars & Trucks
Oct 15, 2011 | 2000 Mercury Sable
Jul 26, 2011 | Mercury Sable Cars & Trucks
Nov 04, 2010 | 2001 Mercury Sable
Sep 29, 2010 | 2000 Mercury Sable
Aug 26, 2010 | 2001 Mercury Sable
May 18, 2010 | 2002 Mercury Sable
Jan 12, 2010 | 2001 Mercury Sable
Jun 21, 2009 | 2000 Mercury Grand Marquis
200 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: