20 Most Recent 2000 Husaberg Fe 600 E SM Questions & Answers


Hi, Ioan the vast majority of service, parts fiche, and owners manuals on the internet are "FREE" to download and all service manuals contain wiring diagrams in the back pages. The rest usually charge a modest fee of $15 and there is a handful of obscure, rare, obsolete, and very old models that are no longer or never were available and some were never printed in English. The Indian and Philippine markets are usually in E-book format only, for these rare occasions I shall look on eBay and find the cheapest one available. Most of the manuals will cover your exact make, model, and year otherwise one will be provided that comes as close as possible to your bike and will have most of the same info that an exact manual would have. If there is no $ sign after the manual link it is free to download.
To download your manual for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.manualslib.com/manual/1088074/Husaberg-Enduro-Fe-400.html#product-ENDURO%20FE%20600
http://husaberg.org/service-manuals
http://www.cyclebuy.com/husaberg/parts.htm
https://bikez.com/motorcycles/husaberg_fe_600_e_2000.php
https://en.wikipedia.org/wiki/Husaberg

2000 Husaberg Fe... | Answered on Jun 13, 2019


Hi, Anonymous for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Husaberg, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?q=Kick+start+shaft+replace+2000+Husaberg+Fe+600+E+SM&tbm=isch&source=univ&sa=X&ved=2ahUKEwjikaecianiAhXmzVkKHW9sAFkQsAR6BAgIEAE&biw=1440&bih=757
Kickstart Replacement and More
http://mail.lumate.fi/husaberg_service_manual.pdf
https://www.rmstator.com/en_ww/list/parts/Motorcycle/2000/Husaberg/FE_600_E/--
https://www.manualslib.com/manual/1088074/Husaberg-Enduro-Fe-400.html#product-ENDURO%20FE%20600

2000 Husaberg Fe... | Answered on May 20, 2019


How much do you weigh? If you have strong compression, that's what you want.

2000 Husaberg Fe... | Answered on Aug 06, 2009


www.taffmeisters.co.uk/tuning-parts.pdf sells a full range of Husaberg pistons and rings.

2000 Husaberg Fe... | Answered on Jul 01, 2009


and had the bike souped for it. Anyway the throttle is SUPER touchy.. You breath on it and it takes off.. Because of this I ended up dumpin it 30 min after I got on..haha... My question is is there a way to stiffen up the throttle so that i have to crank the grip harder to give it gas? I am very inexperienced, and when it took off, i tensed up, hittin the throttle even harder. I know i will appreciate the the responsiveness when I get more experience, but i dont want to die in the process..lol.. thanks for you help! ,UYou need to learn to hold on to the bike with your legs, so you aren't pulling on the bars during acceleraion. The throttles are supposed to be easy to turn, so that it will snap completely closed when you let off. You can replace the throttle cam (the part that the cable attaches to) with a slower-opening unit that will give you more control. The amount you have to turn the throttle from closed to full-open will stay thesame, but it will open slower in the first half of the throttle pull, keeping you from getting such an abrupt surge of power. Once you get a little more time on the bike, you won't have this issue any longer. You will learn proper throttle control, and your wrist will get used to the throttle pull. ,,,

2000 Husaberg Fe... | Answered on Nov 10, 2008


There are usually two methods to check the oil. One is a dipstick and the other is a sight-glass. You should have one or the other somewhere on the side of the engine crankcase. It should be fairly obvious and not require the removal of any body panels. If you can't find a dipstick in the side of the crankcase you will need to get down on your hands and knees and have a look for a sight-glass instead. This will be like a tiny window with a gauge against which you can check the level.

2000 Husaberg Fe... | Answered on Nov 10, 2008


you need a micrometere or vernier caliper to measure how thick they are that how you tell how worn the clutch is. the manual will list the specificational limit (how thin you should allow them to get and how do the basket and innser hub looks like). if they have small teeth on them they are worn.,

2000 Husaberg Fe... | Answered on Nov 10, 2008


i always just put some on the o-ring before i put it back in but no you dont need to have oil on it,

2000 Husaberg Fe... | Answered on Nov 10, 2008


but when the bike's stood for over 4 hours it's flat Confused Even with the main switch off Any ideas?OK beg,borrow, or steal a multitester with current(amps) reading on it. 10 amps is more than ideal, but you will probably need less after initial tests. Ammeters need to be in series, not in parallel like volt testers, so disconnect one battery lead(either will do) and complete the circuit by putting the multimeter leads between the battery lead(disconnected) and the battery terminal. You are now gonna see on the meter, every amp pulled from the battery. turn the ign on and turn a light on, you will see the current rise, as amps are drawn, ok! Turn the ignition off and see what happens. Probably with it set on the 10amp scale youll see nowt, so go down the range on the meter into milliamps, and my guess is that you will see a reading. You shouldnt see anything at all with ign off, but Id guess you can see a few milliamps on the gauge. If this is the case, proceed as follows: One by one, remove the bikes fuses and replace them, if at any point the reading drops to zero you have found the circuit which is sucking the power. If that fails, try again, but one by one undo (every) multiplug on the bike, again one of em should cause the reading to drop. When you have found a fuse or a plug that causes the meter to read zero amps, check that circuit. Maybe there is a wire rubbing onto the frame, a switch corroded internally, or similar, but now you know the bit you need to fix. If you connect the meter as described and there is NO current drain, you are either special! or leaving the side light circuit on(muppet!) good luck.,,,

2000 Husaberg Fe... | Answered on Nov 10, 2008


Hi, Anonymous and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Vacuum line from the petcock to intake manifold cracked.
5. Float needle and seat sticking.
6. Float level too low.
7. Carburetor bowl vent line clogged/blocked/pinched.
8. Idle adjusting screw set too low.
9. Air/fuel mixture screw set too lean.
10. Idle port, transfer ports, slow air jet clogged.
11. Slow fuel jet clogged.
12. Faulty fuel pump.
13. Faulty auto choke or wiring connection.
For more information about your issue and valuable "Free" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://husaberg.org/fuel/5956-only-runs-choke-any-hints.html
WHY your motorcycle only runs on CHOKE
https://www.repair-manuals.eu/cat/motorcycle_repair_workshop_manuals/repair_manuals_husaberg
http://www.cyclebuy.com/husaberg/parts.htm
https://www.manualslib.com/manual/813892/Husaberg-E-400-E.html#product-FC%20550/4

Husaberg... | Answered on Jun 13, 2019


Hi, Anonymous for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Husaberg, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?q=Replace+the+battery+2002+husaberg+470-fxe&source=lnms&tbm=isch&sa=X&ved=0ahUKEwjHooyGkObiAhXqqFkKHcIWB3kQ_AUIESgC&biw=1440&bih=757
http://husaberg.org/electrical/9274-new-owner-fx-470-2002-battery-replacement-question.html
http://husaberg.org/mechanical/11215-workshop-manual.html
http://www.cyclebuy.com/husaberg/parts.htm
https://www.manualslib.com/manual/640214/Husaberg-05.html

Husaberg... | Answered on Jun 13, 2019


The main fuse protects all power consumers of the vehicle. It is located in the starter relay housing under the air filter box lid. (A spare fuse is located in the starter relay)

The fuse box containing the fuses of individual power consumers is located under the seat

Husaberg... | Answered on Feb 26, 2017


Hi, Pete and the usual suspects are:
1. Severely drained or faulty battery.
2. Faulty regulator/rectifier or high output coil.
3. Faulty power valve, solenoid or installation.
4. Clogged air filter or exhaust.
5. Cracked or incorrect float level.
6. Float needle is not seating.
7. Faulty reed valve.
For more information about your question please visit the website below. Good luck and have a nice day.
HUSABERG Pure Enduro Service

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Husaberg... | Answered on Nov 11, 2015


Its a long shot, but try Youtube.
They have tons of DIY videos.

Husaberg... | Answered on Jan 08, 2015


Basically the only way water can get in the oil is if there is a corrosion hole in the housing behind the pump impellor. Water pumps have only 1 seal and if that leaks water will drain from a hole in the pump housing under neath the pump.

Husaberg... | Answered on Mar 11, 2013


under the seat. go to manuels.com and read the manual.lol

Motorcycles | Answered 6 hours ago

Not finding what you are looking for?
2000 Husaberg Fe 600 E SM Logo

11 questions posted

Ask a Question

Usually answered in minutes!

Top Husaberg Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5944 Answers

Marvin
Marvin

Level 3 Expert

85178 Answers

Strech
Strech

Level 3 Expert

1562 Answers

Are you a Husaberg Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Fe 600 E SM Husaberg

  • Fe 600 E SM Husaberg

Most Popular Question

husaberg 600 wont start kick

  • Motorcycles
Loading...