20 Most Recent 2005 Husaberg Fe 650 e Questions & Answers


Hi, Anonymous and the usual suspects are:
1. Low coolant level.
2. Restricted radiator air flow.
3. Faulty thermostat.
4. Coolant pump or fans inoperative.
5. Vent hose crimped.
6. The air in the coolant and needs bleeding.
7. Engine idling too long or bike moving too slow.
8. Coolant too old needs to be replaced.
9. Faulty temperature sensor, wiring or connector.
10. Radiator veins clogged or corroded needs repair
11. Cooling system leak.
12. Ignition timing retarded.
13. Spark plug heat range too high.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://husaberg.org/cooling-systems/1225-04-fe650e-overheating.html
Never Overheat Again The Cure
https://www.tradebit.com/filedetail.php/277018537-husaberg-fe450-fe501-fe550-fe650e-2004-2005 $15
http://www.cyclebuy.com/husaberg/parts.htm
https://www.husabergshop.se/documents/00670_%C4gar_Handbok.pdf

2005 Husaberg Fe... | Answered on Jun 13, 2019


i always just put some on the o-ring before i put it back in but no you dont need to have oil on it,

2005 Husaberg Fe... | Answered on Nov 10, 2008


Hi, Anonymous and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Vacuum line from the petcock to intake manifold cracked.
5. Float needle and seat sticking.
6. Float level too low.
7. Carburetor bowl vent line clogged/blocked/pinched.
8. Idle adjusting screw set too low.
9. Air/fuel mixture screw set too lean.
10. Idle port, transfer ports, slow air jet clogged.
11. Slow fuel jet clogged.
12. Faulty fuel pump.
13. Faulty auto choke or wiring connection.
For more information about your issue and valuable "Free" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://husaberg.org/fuel/5956-only-runs-choke-any-hints.html
WHY your motorcycle only runs on CHOKE
https://www.repair-manuals.eu/cat/motorcycle_repair_workshop_manuals/repair_manuals_husaberg
http://www.cyclebuy.com/husaberg/parts.htm
https://www.manualslib.com/manual/813892/Husaberg-E-400-E.html#product-FC%20550/4

Husaberg... | Answered on Jun 13, 2019


Hi, Anonymous for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Husaberg, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?q=Replace+the+battery+2002+husaberg+470-fxe&source=lnms&tbm=isch&sa=X&ved=0ahUKEwjHooyGkObiAhXqqFkKHcIWB3kQ_AUIESgC&biw=1440&bih=757
http://husaberg.org/electrical/9274-new-owner-fx-470-2002-battery-replacement-question.html
http://husaberg.org/mechanical/11215-workshop-manual.html
http://www.cyclebuy.com/husaberg/parts.htm
https://www.manualslib.com/manual/640214/Husaberg-05.html

Husaberg... | Answered on Jun 13, 2019


The main fuse protects all power consumers of the vehicle. It is located in the starter relay housing under the air filter box lid. (A spare fuse is located in the starter relay)

The fuse box containing the fuses of individual power consumers is located under the seat

Husaberg... | Answered on Feb 26, 2017


Hi, Pete and the usual suspects are:
1. Severely drained or faulty battery.
2. Faulty regulator/rectifier or high output coil.
3. Faulty power valve, solenoid or installation.
4. Clogged air filter or exhaust.
5. Cracked or incorrect float level.
6. Float needle is not seating.
7. Faulty reed valve.
For more information about your question please visit the website below. Good luck and have a nice day.
HUSABERG Pure Enduro Service

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Husaberg... | Answered on Nov 11, 2015


Its a long shot, but try Youtube.
They have tons of DIY videos.

Husaberg... | Answered on Jan 08, 2015


Basically the only way water can get in the oil is if there is a corrosion hole in the housing behind the pump impellor. Water pumps have only 1 seal and if that leaks water will drain from a hole in the pump housing under neath the pump.

Husaberg... | Answered on Mar 11, 2013


Hi, Anonymous and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Vacuum line from the petcock to intake manifold cracked.
5. Float needle and seat sticking.
6. Float level too low.
7. Carburetor bowl vent line clogged/blocked/pinched.
8. Idle adjusting screw set too low.
9. Air/fuel mixture screw set too lean.
10. Idle port, transfer ports, slow air jet clogged.
11. Slow fuel jet clogged.
12. Faulty fuel pump.
13. Faulty auto choke or wiring connection.
For more information about your issue and valuable "Free" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.howtomotorcyclerepair.com/onlyrunsonchoke
WHY your motorcycle only runs on CHOKE
https://thumpertalk.com/forums/topic/291948-bike-only-runs-with-choke-on
https://www.hdforums.com/forum/dyna-glide-models/725647-no-brake-light-function-on-my-dyna-low-rider.html https://thumpertalk.com/forums/topic/291948-bike-only-runs-with-choke-on

Motorcycles | Answered 19 minutes ago


Hi, Anonymous and the usual suspects are:
1. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
2. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
3. Faulty main circuit breaker and or connections.
4. Faulty ignition coil and or connections.
5. Faulty spark plug, oil or gas fouled, wrong heat range or service type, wrong gap, loose in the cylinder head, broken electrode or insulator.
6. Faulty spark plug cables, leaking or broken, internal damage check for spark leakage in the dark.
7. Faulty ignition module, switch, CKP, MAP, CMP, sensor and or any connector in the ignition circuit could have corroded, loose, or broken pins/sockets
8. Burnt exhaust valve or air leak in the exhaust system.
9. Improper valve clearance (too tight).
10. Check for generated diagnostic codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.doityourself.com/stry/5-tips-to-preventing-backfire-on-motorcycle-exhausts
https://noobnorm.com/motorcycle-backfire-causes
https://www.youtube.com/watch?v=eSky1ZfHdhA
https://noobnorm.com/motorcycle-backfire-causes
https://itstillruns.com/stop-motorcycle-from-backfiring-2221631.html

Motorcycles | Answered 2 hours ago


Hi, Ted for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your BSA, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://bsac10c11c12.co.uk/smf/technical/ignition-timing-a-c11
https://www.google.com/search?q=Ignition+timing+1952+BSA+C-11&tbm=isch&source=univ&sa=X&ved=2ahUKEwjkl5L6n4LjAhVnzlkKHV7RCUUQsAR6BAgAEAE&biw=1440&bih=757
https://www.youtube.com/watch?v=WhI2v_j7Qzo
https://partsbooks.britishonly.com/partsbooks/PDF_Files/bsa/SectionC.pdf
https://partsbooks.britishonly.com/partsbooks/20-10146C.pdf

Motorcycles | Answered 10 hours ago


I didnt see one on line for free download, (just too rare), but if your interested, theres one for sale on Ebay.

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F401243023481

Motorcycles | Answered 22 hours ago


if you need some scan tool, I recommend you the Motorcycle Scan Tool

Motorcycles | Answered 2 days ago


Hi, Anonymous for more information about your question and valuable "FREE" downloads that you will need please click on the websites below. Good luck and have a nice day.
Linhai Big Horn 4 wheeler fuel line diagram Google Search
https://amsportworks.com/pdfs/ATV/talon/2007talon_ownersmanual_pages01-39.pdf
Fuel and Vac Line Tutorial
ATV Connection

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Motorcycles | Answered on Jun 20, 2019

Not finding what you are looking for?
2005 Husaberg Fe 650 e Logo

Popular Tags

3 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Husaberg Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5884 Answers

Marvin
Marvin

Level 3 Expert

85020 Answers

Strech
Strech

Level 3 Expert

1562 Answers

Are you a Husaberg Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Fe 650 e Husaberg

  • Fe 650 e Husaberg

Most Popular Question

05 fe650 new head gasket new water pump

  • Motorcycles
Loading...