Question about 2005 Husaberg Fe 650 e

1 Answer

Overheating 2005 Husaberg Fe 650 e

05 fe650 new head gasket new water pump seal still overheating. Why? @

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Husaberg Master
  • 56,994 Answers

Hi, Anonymous and the usual suspects are:
1. Low coolant level.
2. Restricted radiator air flow.
3. Faulty thermostat.
4. Coolant pump or fans inoperative.
5. Vent hose crimped.
6. The air in the coolant and needs bleeding.
7. Engine idling too long or bike moving too slow.
8. Coolant too old needs to be replaced.
9. Faulty temperature sensor, wiring or connector.
10. Radiator veins clogged or corroded needs repair
11. Cooling system leak.
12. Ignition timing retarded.
13. Spark plug heat range too high.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://husaberg.org/cooling-systems/1225-04-fe650e-overheating.html
Never Overheat Again The Cure
https://www.tradebit.com/filedetail.php/277018537-husaberg-fe450-fe501-fe550-fe650e-2004-2005 $15
http://www.cyclebuy.com/husaberg/parts.htm
https://www.husabergshop.se/documents/00670_%C4gar_Handbok.pdf

Posted on Jun 13, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
localwonder
  • 6784 Answers

SOURCE: 2000 Sunfire coolant problem. Engine overheating,

ok, its time for a radiator flush. there is major sludge in the internals of this radiator. Make sure the thermostat is in the correct position as well. I've seen many cars come into my shop with the thermostat inserted backwards.

Posted on Mar 13, 2009

goofduck
  • 490 Answers

SOURCE: getting water in the crank case

if i had to guess at this one the seal behind the impeller on the water pump is bad

Posted on Apr 12, 2009

  • 35 Answers

SOURCE: my 1995 dakota is overheating, replaced water pump, thermostat, fan. What to do????

if the fan is working properly, the only thing left to check is the radiator...

i may be clogged or damaged so the water can't travel in it properly...

Posted on Apr 29, 2009

  • 1129 Answers

SOURCE: 2006 Dodge Magnum keeps overheating

Observe the car's engine as it runs for 10 minutes to ensure that the electric fan for the radiator is coming on, if not either the fan relay, fan's coolant temp. sensor, or the fan itself is bad, try the relay first it is the least expensive, if this is the type of vehicle that has no electric fan replace the clutch fan.

Posted on Jul 29, 2009

  • 3567 Answers

SOURCE: 05 yz250f milky oil

milky oil is water mixed into the oil. Replacing the seals should fix the leak. Nothing special on the top end gasket.

Posted on Sep 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2005 KIA SPECTRA OVERHEATING WHEN ANTIFREEZE IS ADDED LOOKS LIKE IT COMES OUT SOME WHERE BEHIND THE WATER PUMP


Have the cooling system pressure tested, this lets you id the source of the leak quickly.

Dec 14, 2016 | Kia Cars & Trucks

1 Answer

Head gasket or IM gasket? overheating, think there's antifreeze on spark plug threads. drained flushed bled system. new thermostat rad cap. still overheating.


Somebody been using tap water in their radiator? The vehicle is old enough to have a lot of accumulated rust and crud in the Radiator which, depending on relative water quality and location of water pump could over pressure the system and have it squirting into overflow. If the threads of the plug have antifreeze on them it's coming from the OUTSIDE not the inside.

Apr 15, 2014 | 2005 Buick Rendezvous

1 Answer

Toyota MR2 spyder engine failure


It seems a bad idea , Just doing a good repair is like new :

replace head valves seals
replace head gasket , also check head plain
check cylinders for wear
repalce piston rings

Jul 07, 2017 | 2005 Toyota MR2 Spyder

1 Answer

Water pump seals


Basically the only way water can get in the oil is if there is a corrosion hole in the housing behind the pump impellor. Water pumps have only 1 seal and if that leaks water will drain from a hole in the pump housing under neath the pump.

Mar 11, 2013 | Husaberg Motorcycles

1 Answer

Ford f350 overheating


I have a 2005 F350 and mine was doing the same thing. We changed everything including replacing a new factory overflow cap. Finally, we found that the head gasket was leaking causing the engine to overheat but also I was loosing a ton of horsepower. We rebuilt the engine from the head gasket and new heads all the way to the top of the engine. We replaced the head bolts with new head studs and it feels like a new truck. More horsepower and it pulls like the beast that it was meant to be. Hopefully, this helps good luck.

May 31, 2012 | 2005 Ford F 350 Super Duty

1 Answer

After spending 880 dollors on having a head gasket water pump and radiator replaced in my 1998 pontiac sunfire 2.2 liter it has no flow thru the brand new radiator engine runs supur hot 260 degrees in 2...


YOU COULD HAVE A DEFECTIVE WATER PUMP OR THERMOSTAT ALSO RADIATOR PRESSURE CAP.MAKE SURE YOUR WATER PUMP IS BEING TURNED BY DRIVE BELT.NOT SLIPPING.MAKE SURE COOLANT SYSTEM HAS BEEN BLED AND YOU HAVE HALF ANTIFREEZE HALF WATER.CHECK YOUR CRANKCASE WHEN CAR COOLS DOWN.IF OIL STILL LOOK LIKE MILK SHAKE.YOUR NEW HEAD GASKETS LEAKING.THE MECHANIC WHO REPLACED HEAD GASKET DIDNT DECK THE HEADS.THEY PROBABLY NEED SHAVED A LITTLE SO HEAD GASKET WILL SEAL.

Nov 11, 2009 | 1998 Pontiac Sunfire

1 Answer

I just got the water pump and timing belt replaced on a 2002 Hyundai Santa Fe v6 because antifreeze was leaking from that area and the SUV was overheating- i didnt let it get too high and it was leaking...


Could be intake gasket, head gasket or leaking bolt that didn't get sealed. You can use sealer but sometimes it does more damage then good. I don't use it on any vehicles that come in because of sometimes plugging more then it should, like the radiator and then causing over heat issues. But you can try it if you wish.

Sep 11, 2009 | Hyundai Santa Fe Cars & Trucks

Not finding what you are looking for?
2005 Husaberg Fe 650 e Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Husaberg Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5884 Answers

Marvin
Marvin

Level 3 Expert

85020 Answers

Strech
Strech

Level 3 Expert

1562 Answers

Are you a Husaberg Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...