2000 Chevrolet Silverado 1500 "ignition lock cylinder replacment" Questions

Ad

Question about Chevrolet Silverado 1500

2 Answers

...lock cylinder from the ignition switch, when installing the cylinder align the retainer with the retainer slot in the housing, push the cylinder in until it snaps in position.when replacing ignition ...

Ad

Question about Chevrolet Silverado 1500

2 Answers

...Ignition Lock Cylinder disconnect battery, pull steering wheel, need a puller, then compress lock pale, need tool for that too, take the snap ring out and remove lock plate, remove 4 way flasher ...

Ad

ignition switch that may have to be replaced. This may occur because of problems with the lock cylinder or the underlying electrical switch. If you notice the discrepancy whereby the headlights switch

i replaced steering column and used same ignition key and now wont start and securety is flashing. What do i do? Not clear what you mean. Did you replace the column and reuse the old lock cylinder?

Question about Chevrolet Silverado 1500

1 Answer

...ignition key the switch tend to lock i have to playu with steering wheel and play with key trying to turn it on rapidly after five of six attempts it will eventually turn and fire up the truck. is ...

Question about Chevrolet Silverado 1500

1 Answer

ignition will not turn. What can I do to start it? Make sure battery is charged. With key in tap the end of it firmly with small hammer while trying to turn it. Then take it to someone who can replace

...ignition's lock cylinder, and then to the car's TDM (Theft Deterrent Module). These 3 parts are in CONSTANT communication. If the key is in the ignition, then these parts are sending signals to each ...

...ignition lock cylinder. Failure of the sensor in the ignition lock cylinder can cause symptoms you're describing, but is also accompanied by a security light illuminated on the dash, and a diagnostic ...

...ignition switch in the steering column. Not the lock cylinder. Dealer recomended replacing switch, but i took the cover off bottom of column and found a loose wire. Plugged it in and havent had any ...

Question about Chevrolet Silverado 1500

1 Answer

...is going to be the ignition switch/lock cylinder that needs to be replaced. After you replace the switch you may need to do the passlock procedure which you can just google it. Hope that

Not finding what you are looking for?
Cars & Trucks Logo

1,730 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...