Maytag Atlantis MAV6000 Top Load Washer - Answered Questions & Fixed issues


Your problem sounds like a broken belt . Check and replace. Good Luck Friend.

Maytag Atlantis... | Answered on Jan 30, 2018 | 194 views


When you opened the lid to add clothes, your Maytag sensed a door lock fault and went into protective shutdown.

Maytag Atlantis... | Answered on Jan 04, 2018 | 151 views


it sounds like there is something stuck in the water pump you will need to lay the water outlet on the floor into a shallow vessal to empty it then that the back off locate the water pump and see if you can rotate the cooling propeller if not take the motor housing apart to remove the debris that's preventing it from turning if the motor has not burnt out eric

Maytag Atlantis... | Answered on Jan 01, 2018 | 282 views


Hi Greg.
this is all i could find,go to this link and see if it helps you out.
Maytag Atlantis washer Model MAVT754EWW how to clean the hose Screens that...

Maytag Atlantis... | Answered on Nov 04, 2017 | 200 views


The model number would help, ya know?

Maytag Atlantis... | Answered on Oct 03, 2017 | 569 views


I would not fix it myself .

Maytag Atlantis... | Answered on Aug 23, 2017 | 575 views


Press 2 metal tabs. About 6" from the sides on the front of washer. Plastic ring on top has tabs that need to be disengaged to disconnect the ring. Once ring has been removed the area between the plastic tub & metal tub is accessible. Check for small articles of clothing, like socks or underwear. Inner tub can be removed by: snap up plastic cap (small slot for tool to slip in and pop up). Remove 7/16 nut and remove agitator (may require to be rocked back & forth, sits on a splined shaft). Remove 5 small phillips screws, being careful not to drop any, and pull inner metal tub up (may require it being shimmied back and forth). Removing this tub will give full access to any debris or articles of clothing that may be under it. Please keep in mind that if you're challenged in reassembly

Maytag Atlantis... | Answered on Jun 16, 2017 | 131 views


Go to www.repairclinic.com and enter MAV6000. With luck, you will be presented with a list of common replacement parts and may be able to view a generic Maytag video showing disassembly and replacement.

Maytag Atlantis... | Answered on May 24, 2017 | 252 views


Realistically, a 10-year old Maytag is nearing the end of its usual life. The pump may be leaking at random times during a wash cycle. If you put 50% of the cost of a new one into repairs, it is time to thing seriously about replacement of the machine.

Maytag Atlantis... | Answered on Apr 26, 2017 | 133 views


Hi,

Start the washer in a normal cycle, once it starts to fill, unplug the unit from the wall. If the water stops completely its not a water valve issue. If it still drips, replace the water valve to the washer. Good Luck

I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

Maytag Atlantis... | Answered on Apr 19, 2016 | 88 views


There are 2 screws behind panel. Remove to lift panel, remove the 2 clips and disconnect lid switch connector. You can then lift body off frame.

Maytag Atlantis... | Answered on Mar 17, 2016 | 54 views


Remove top cover, take out the bolt remove the small cover to expose the plate with several screws,remove the screws and lift the inner tub up. Usually this requires two people to get the tub up and out as it is very hard to pull up as it kind of sticks to the shaft

Maytag Atlantis... | Answered on Feb 10, 2016 | 316 views


clean the lint filter in the machine

Maytag Atlantis... | Answered on May 03, 2015 | 182 views


Check balance spring adjusters are locked off. Could be the base warping, if so it will need replacing.

Maytag Atlantis... | Answered on May 02, 2015 | 65 views


No spin, or lite spin try these:

Using a multi meter check for continuity the door switch, which when bad may not allow agitation or spin. The lid switch assembly can fail either mechanically or electrically.

Check the clutch, brake assembly and transmission, one way to check for slipping is to get under the machine after a spin cycle ( this is if u get a lil spin but not much leaving clothes still wet) mix in a spray bottle a lil water and some dish detergent, then spray it on the clutch assembly ( the metal round pc. Connected to the tranny) if it sizzles and steams up then u know its bad and slipping. Another way to check clutch if u get no spin at all? Is to take it out and use ur hand to try and turn the inner spring assembly pushing it around the inside? If its very easy, it BAD should be hard to push by hand.


Next check the motor coupler which engages the tub and tranny to the motor. ( if its bad u usually get no wash or spin or very little of either)

Next check for a loose, worn or broken belt if belt driven.

On some front load models u may need to check the STATOR assembly.
The stator is essentially one half of a motor, it interacts with the tub by creating a strong electro-magnet. If the stator burns out the washer won't spin or agitate. Check the stator for continuity. This part is often misdiagnosed.

Sometimes a no spin machine can be due to a plugged waterpump hose or obstructed water pump propeller. Check these by eye and hand.





Maytag Atlantis... | Answered on Apr 13, 2015 | 64 views


I suspect bad motor windings. it has enough power to run delicate but not other cycles?

Maytag Atlantis... | Answered on Mar 09, 2015 | 187 views


may have blown a fuse check in the panel and also check to see if it has a thermal fuse included, I would also check the door switch as it can cut off all power also

Maytag Atlantis... | Answered on Feb 20, 2015 | 251 views


RDU Appliance Repair 919 827 1482 Serving Raleigh Cary Durham NC

mav7600aww has a brake that goes bad. some will just spin slowly during agitate cycle and not really agitate

Maytag Atlantis... | Answered on May 15, 2015 | 228 views

Not finding what you are looking for?
Maytag Atlantis MAV6000 Top Load Washer Logo

1,252 questions posted

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

jimorris77

Level 3 Expert

411 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

Bill Long

Level 3 Expert

606 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...