Question about Mitsubishi WD-62526 Projection TV

1 Answer

My mitsubishi tv is almost 3 years old and it has no picture but it has sound

Mitsubishi WO-60737 TV 60 inch 180p projection

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 597 Answers

Video board malfunctioning....Get a honest TV tech. Only three years old? It is worth repairing, will deliver several more years of excellent service. A quality television.

Posted on Nov 14, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: mitsubishi model vs-5043

I just had this same exact problem. I looked for an answer on here and could not find one. So I took the back off, vacuumed and cleaned everything out with the hose on my house vacuum, cleaned the bulbs and wiggled them around some. Voila !!!! lights on and all is working fine and better then ever. I hope this helps someone fix their problem. Just saved me tons of money and a morning of hassle.

Posted on May 06, 2008

  • 320 Answers

SOURCE: Mitsubishi screen replacing

You must remove the front bezel and frame holder to replace the screen. You will usually see the screws holding the from from the rear of the unit. Once you get the frame off, take note of the way the old screen is installed. There is usually a label on one side near the bottom; the new screens must be installed with the label in the same location. The lenticular goes on the outside (facing the viewer) and the fresnel goes on the inside facing the mirror. You will be able to recognize the fresnel, it has a series of concentric circles that are raised on the sirface of the plastic Be sure to rate this solution.Thanks!

Posted on Nov 08, 2008

  • 8 Answers

SOURCE: Mitsubishi 80 inch rear projection tv

I will be getting one of these tv's in the next couple of weeks and I will be parting out all of the internal electronics, tubes and lenses. drop me an email. kievsavoie@hotmail.com

Posted on Feb 28, 2009

  • 1 Answer

SOURCE: Mitsubishi 50 inch projection tv

you probably have a problem with the convergence board.

Posted on Apr 05, 2009

rulds2008
  • 3866 Answers

SOURCE: My 10 year old 55 inch Mitsubishi rear projection shuts off.

The main board/switch is worn to the point it will not work anymore after a while, I been in the business for years, These are wonderful TV's, yes there are replacement parts but a quick fix your looking for here will be unsuccessful this is the reason I am providing my advice and take a chance on the rating your going to give me. Try www.ebay.com look for people that is saling parts for these TV's.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

Posted on May 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

60 inch mitsubishi comes on no picture only sound and then it will turn off by its self


Most mornons seem to think that your TV is a traditional crt projection when in fact it is a DLP projection set and does not have convergence chips or CRTs. Instead, your set has a DMD chip and a projector lamp that passes light through the light engine where a color wheel is and the DMD chip itself. Often times DLP TVs cycle on and off again when the lamp is starting to go out. Mitsubishi is well known for this. However, it can also be a symptom of the color wheel going bad as well or simply updating the software by downloading it from http://support.mitsubishi-tv.com/
Good luck and rate me when you can.

Nov 30, 2011 | Mitsubishi WD-60737 60 in. HDTV

1 Answer

I have a Mitsubishi WD-60737 60 in. HDTV TV and the picture is blurry at the bottom. What can I do?


If your cables are secure you could have a signal board issue. I would contact the manufacturer.

Oct 24, 2011 | Mitsubishi WD-60737 60 in. HDTV

1 Answer

Mitsubishi DLP - WD-60737 - 1 year old I have sound but no picture. The lamp is not lighting up. I have already replaced the lamp. After I replaced it, the set worked fine for a couple of hours, but is...


Hi,
This tv has self diagnostic feature that will show last error through front light blinks, there is procedure to activate and read out error code to diagnose problem section of tv to solve its issue so to get tv back in business.
Let me know to proceed.
Thanks.

Mar 03, 2011 | Mitsubishi WD-60737 60 in. HDTV

1 Answer

My mitsubishi Model # WD-60737. It is lesss than a year old. The status light flashs green, the Mitsubishi blue start up page comes up the the tv cuts back off. I have unplug from the wall for an hour....


Tv under a year old call Misubishi for a warrenty repair.Flashes staus light mean could be any these parts have problems power supply board,Ballast board or the pojection lamp itself.

Jan 11, 2011 | Mitsubishi WD-60737 60 in. HDTV

1 Answer

My mitsubishi Model # WD-60737. It is lesss than a year old. Maufactered Feb 2010. The status light flashs green, the Mitsubishi blue start up page comes up the the tv cuts back off. I have unplug from the...


i had the same problem and i called mitsubishi they said it is a software malfunction and they are sending me an update to install via flash drive. i am now awaiting the email

Nov 28, 2010 | Mitsubishi WD-60737 60 in. HDTV

1 Answer

I have a mitsubishi 60 inch tv model wd-60c9 and i purchased it this year ..aug 06 2010 and the picture has became very dark..i am using hdmi conection and purchased new and better cables..issue still dark


The tv projection lamp have problems,it shorting out some how.That why,u have a dim picture.Tries websites like Partstore.com,Ebay.com to buy a new projection lamp for the replacement.New tv,call mitsubishi for a warrenty repair.

Oct 18, 2010 | Mitsubishi WD-60C9 60" DLP HDTV

1 Answer

My Mitsubishi VS-60621 seems to have a convergence problem


Projection TV2_bing.gif sets have several common problems listed below.

Problem #1) Convergence

Symptoms:

  • Screen Looks 3D
  • Colors wont align
  • Screen may look distorted
  • No Audio/Video - TV2_bing.gif makes a chirping sound.
Problem #2 CRT Fluid has clouded over. Symtoms
  • Dull looking video
  • White looking video
  • Halos around objects
  • Red/Orange looking video

You can see some examples and find a fix here...

bb0cf99.pnghttp://www.fixya.com/support/r2861467-solution_video_looking_whiteish_dull

Mar 05, 2010 | Mitsubishi VS-60621 60" Rear Projection...

1 Answer

Mitsubishi VS-60609 60 in. no pix /has sound


My Mitsubishi TV model VS 60609 is showing double vision on the screen.

Feb 24, 2009 | Mitsubishi VS-60609 60" Rear Projection...

1 Answer

I have a Mitsubishi VS-60.. With a Picture


Vertical IC outputs , vertical Capacitors are most like the culprit on your deflection panel. good luck

Aug 16, 2007 | Mitsubishi VS-50501 50" Rear Projection...

Not finding what you are looking for?
Mitsubishi WD-62526 Projection TV Logo

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1257 Answers

The Knight
The Knight

Level 3 Expert

76140 Answers

Jaime Hernandez

Level 3 Expert

2337 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...