Question about Westinghouse Televison & Video
LED TV ......I SEE THE "W" LOGO FOR 2 SECONDS THEN NO PICTURE NO SOUND BUT RED LIGHT STAYS ON
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I just fixed the same model and with your symptom. What it appears to be is the main module is locking up just after the Logo goes away. All you can do is unplug and try again and all you will get is the logo for 5 seconds and then black screen, no sound and led stays lit. Cannot turn off or on. The power supply is actually working fine, it's the main module that has died. This module is no longer available, the part number was W470PROLX68. What i did to restore operation on this unit was to insert 3 volts into the plug going to the master inverter board and then plugged the tv AC cord in. The set showed the logo and then it started working. I removed the 3 volts and it has worked every time since then.
Here is what you should try to do: First take two AA batteries and solder them in series and attach two short wires so you can use it as a power source. Now you have a 3 volts power supply. Next Remove the stand first before removing the back cover. Looking at the back of the unit you will see the power supply and the main circuit boards in the middle (under metal shields) and two boards on each side. These are partially covered with a metal shield, the one on the left side is the master inverter, the one on the right is the slave inv. They both have a plug and wires going to them from the power supply, but the one to the master will have two extra wires. I believe the colors are purple and blue, and they are separated with an empty hole (unused part of the plug). The wire on the end is where you will hook up the positive lead of your battery pack. The negative lead simply goes to the metal shield. With these hooked up plug the tv into the ac and give it a couple seconds and hopfully you will see the tv come on. If it does then disconnect the battery pack and try it without it. good luck.
Posted on Nov 17, 2009
Tips for a great answer:
Sep 03, 2017 | LG Televison & Video
Jun 10, 2017 | Westinghouse Televison & Video
May 07, 2016 | Vizio Televison & Video
May 02, 2013 | Westinghouse 55" 1080p 120hz LCD HDTV -...
Dec 12, 2012 | Westinghouse LTV-30W2 Television
Sep 17, 2010 | Westinghouse LTV-32w4 32.02 in. LCD HDTV
Jul 15, 2009 | Westinghouse Electric VK-40H580D 40 in....
May 03, 2008 | Sony Grand WEGA KDF-55XS955 55" Rear...
261 people viewed this question
Usually answered in minutes!