Question about Beko Washing Machines
Start by turning the washing machine of with door shut.
Now turn the dial to the position 1 Which is normally the 90c hold the start /pause button down while you press the on/off button to on for a couple of seconds till light flashes
Now turn the dial to the position 6 and hold down a few seconds the next time you enter it should turn on all the lights now you are in self test diagnostic mode:
Every time you Press the on/off button it will change the test function.
1st all the lights will show
2nd will not do anything
3rd This will tell the motor to turn at standard wash speed clockwise with pump emptying.
4th This will tell the motor to turn at standard wash speed anticlockwise with pump emptying.
5th This will tell the motor to spin clockwise with pump emptying.
6th This will activate right hand compartment water valve. Please note machine will keep filling until you stop it.
7th This will activate left hand compartment water valve. Please note machine will keep filling until you stop it.
8th This will activate booth water valves together. Please note machine will keep filling until you stop it.
9th will not do anything
10th this will start fill cycle until water activates the pressure switch at normal fill level (Normally just below the glass on the door) when the Beko washing machine has reached the level it will start clockwise rotation at normal wash action and heat the water. Please note You Have to stop it manually.
11 this will activate the pump only to empty.
Press again and you are back at the start. Turn machine of and leave for a few minutes and the switch back on and you're in normal wash mode.
Posted on Jan 12, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
remove rear cover of washer, locate and remove belt.
Unfasten motor ,disconnet motor lead, and remove motor.
Brushes are located at opp end to motor pulley.
Replace if less than 5mm long.
Plz rate my solution.
Posted on Jan 21, 2009
Please download asap - as it is stored on my personal FTP site, and will be removed in 48 hours.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question
Head over to the manufacturer's website.
Typically they have a SUPPORT section - where you enter the FULL model number, and then can download a FREE manual.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question!!!!!!!!
Posted on Sep 16, 2010
Tips for a great answer:
Mar 10, 2018 | Beko Washing Machines
Oct 07, 2016 | Beko Washing Machines
May 29, 2016 | Beko Washing Machines
May 10, 2016 | Beko ECO WMB81445LW White 600 mm Washer...
Oct 30, 2015 | Beko Washing Machines
Jan 26, 2013 | Beko Washing Machines
Feb 08, 2011 | Washing Machines
Mar 08, 2008 | Washing Machines
Mar 08, 2019 | Beko Washing Machines
31 people viewed this question
Usually answered in minutes!