Question about Washing Machines
It fills okay on wash cycle, then on rinse cycle cold water only dribbles in. We have had the intake hose off and checked. What can it be
Remove the cold water hose from the back of the washing machine look inside the valve there will be a screening there clean the screen do not remove it and throw it away if you can get the screen out without damaging it you can reinstall it but do not run the machine without that screen in the valve
Posted on Jan 12, 2019
Either screensvin hose and valve are obstructed with debris or water valve is bad.
Posted on Jan 12, 2019
The fill valve could be defective
Posted on Jan 11, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The cold water solenoid valve seems to have failed on you. They're easy to replace and can be purchased at any appliance parts company
Posted on Jun 15, 2009
You may want to double check you have the inlet hoses around the correct way as if you have the cold hose going to the hot valve it would cause this fault. If the machine doesnt spin properly also it could be a faulty Out of balance switch. cheers.
Posted on May 15, 2009
SOURCE: Low Cold Water Flow into Machine
the water inlet valve has to be replaced,its the part where you seen the screen ,where the hose hooks up to,theres a cylinoid that opens and closes and lets the water come in,your cylinoid is no good,but you change it as one unit,and its called water inlet valve,easy fix you can do your self,if this helps please vote me a fix ya
Posted on Jul 15, 2008
well the first thing i would do is take the cold line loose from the washer get a large bucket and open the cold line with the hose off and see what kind of pressure there is if very little need a plumber or in crese your well pump pressure check your screen while you have the hose off if all of this is ok id replace the washer water valves
Posted on Jan 19, 2008
Check for a cold water supply problem by taking a look at the water inlet valve. Remove the water supply hoses and check the small metal screens inside the openings on the valve (especially the cold water side). Make sure they are free of rust or debris. Check the solenoids. They can be tested using a multimeter or ohmmeter. Check for continuity. A lack of continuity means a bad solenoid and the water inlet valve assy will need replaced. Sorry for your trouble and I hope this helped. Best wishes.
Posted on Sep 12, 2009
Tips for a great answer:
Nov 07, 2016 | Whirlpool Washing Machines
Jun 16, 2013 | Washing Machines
Feb 21, 2012 | Fisher and Paykel IWL12 Top Load Washer
If your washing machine will not fill, only hot or cold will fill or is slow to fill then read these tips. I have covered many of the things that can happen in these tips...
Washing Machine Problems No Water
Washing Machine Fix Washing Machine No Water
Mar 03, 2011 | Kenmore 24032\24036 Top Load Washer
Jan 23, 2011 | Washing Machines
Jan 23, 2011 | Maytag LSE7806A Top Load Stacked...
Jul 27, 2010 | Fisher and Paykel IWL12 Top Load Washer
May 23, 2010 | Whirlpool LSR5132PQ Top Load Washer
Jan 21, 2019 | Maytag Washing Machines
32 people viewed this question
Usually answered in minutes!