Question about Washing Machines
Sounds like timer issue...try another setting like delicates and see if it does it.
Posted on Jan 12, 2019
Call a local repair shop
Posted on Jan 12, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Had the same problem, this fixed it!
Posted on Oct 31, 2008
i would try to clean the trap out at the bottom, there is a panel on the bottom take that off and clean out the trap, it looks like a turn dial, something like that has happend to me, it cant hurt to try
Posted on May 28, 2009
If the cycle doesn't advance, it's probably the timer or a cold-water supply problem:
It's the timer, if your washing machine fills with water and begins agitating, but the timer never advances--or if the washer is in a spin cycle and the timer won't advance. Then you need to replace the timer.
It may be a cold-water supply problem, if the washing machine fills with water, agitates, drains, and spins, but then doesn't fill with rinse water. See There's no cold water.
Please do rate this solution as FixYa and revert for further assistance.
Posted on May 29, 2009
SOURCE: maytag neptune TL
The machine needs to cut you a break;
“”i have a maytag neptune TL and there are several things wrong with it...1. I can't wash small loads it will stop at the spin cycle and flash dc””
This issue is a clutch issue see this post to DIY the repair.
“”it will wash fine on regular loads until it comes to spin cycle again and it will stop and flash nf””
This one is a little confusing the “nf” error is a No water fill error code. Check these two post for support regarding water inlet restriction or valve not opening properly.
nf post nf post 2
“”my fabric softener dispenser will not let the softener out neither will the bleach dispenser””
See this fabric softer post for support. The fabric softener dispenser may be clogged or the water dispenser valves feeding both dispensers may not be operating properly. The Service Manual on page 16 “Board Output Test” will give you support to turn on the Fabric Softener Valve and Bleach valve. See if you hear the valves operate in Service Mode”
My method may seem a little confusion for viewing water flow to the dispensers. This issue could be associated to the nf error you are receiving, restricted water flow (inlet screen clog) or cold water valve not working properly.
Post back for any questions or possible support I can offer. I’m an owner like you not a repair person but I’m very comfortable working on this machine. Rich
Posted on Jun 17, 2009
Tips for a great answer:
Jun 10, 2016 | Washing Machines
Apr 16, 2016 | Washing Machines
Feb 06, 2014 | Whirlpool Duet GHW9150P Front Load Washer
Jun 09, 2013 | Frigidaire Washing Machines
Feb 10, 2011 | Fisher and Paykel GWL11 Top Load Washer
Apr 01, 2017 | Electrolux EIFLW55HIW Front Load Washer...
Jan 05, 2018 | Frigidaire ATF6000ES Front Load Washer
Apr 26, 2009 | Washing Machines
Sep 09, 2008 | Whirlpool Ultimate Care II LSQ9549L Top...
Mar 25, 2019 | Bosch Washing Machines
31 people viewed this question
Usually answered in minutes!