Questions & Answers for: overtemp

Ad

Question about Microwave Ovens

1 Answer

...exhaust heat, is it installed with the proper clearances? it is one, not venting and tripping the overtemp, two, the overtemp module is bad, or the board receiving the signal is ...

Ad

Question about RGX4634KQ Gas Dryer

1 Answer

...thermal fuse is good, never hear gas solonoid ckick. Roper RGL4632BW (2 or Z) You have a thermal overtemp sensor that has failed, they are located in maybe two spots, but the diagram on the dryer ...

Ad

Termal overtemp LED light on, welder not working, not overheated Lincoln welder model Invertec V160-S machine lites up but the thermal overtemp LED light is on, the welder is not overheated ...

...the temperature light still comes on. The low water level sensor is in the overflow bottle, not the overtemp sensor. The overtemp sensor will be on the motor somewhere. To check you have the right ...

Question about Neptune MDG5500AW Gas Dryer

1 Answer

mdg5500aww no heat / flame. I have checked the following for continuity. ignitor, overtemp sw., round switch on flame tunnel, 2 round switches on exhaust (plus the previously mentioned overtemp sw.) ...

Question about Neptune MDG5500AW Gas Dryer

1 Answer

I FIND THE ERROR 010-320 WE CAN'T USE THE COPIER, BUT MACHINE IS WORKING That's a fuser overtemp fault, meaning your fuser either has a peice of paper jammed up in the fuser or the thermistor is blown

Question about 2002 S80

1 Answer

engine overtemp overtemp indicator came on ,put in garage to look at and went off overnite without doing any thig to it. Now its back again???? check coolant level

Question about 9120 UPS System

1 Answer

overtemp 'overtemp' code on the readout. What is the likely issue? The cooling fan is probably not working. Unit will overheat. Check the fan to see if it run continuously with no scraping noise with ...

Question about 1999 Passport

2 Answers

...Charlie Transmission will go into a limp mode ( third gear only) when the computer sees and overtemp condition. Need to have the fluid checked and codes pulled. Overtemp usually means trouble ...

...HEATS UP THEN IS LOADED TEMP SEEMS TO FALL AND HAS TO BE RESET If you manually reset by pressing overtemp thermostat, then check your operating thermostat.. maybe over heating.. if so replace ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Microwave Ovens Experts

William Miller
William Miller

Level 3 Expert

9174 Answers

Marvin
Marvin

Level 3 Expert

85178 Answers

Cindy Wells

Level 3 Expert

6026 Answers

Are you a Microwave Ovens Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...