Electronics - Others - Recent Questions, Troubleshooting & Support


https://www.manualslib.com/

Try this site for the manual you are looking for.

Inverter... | Answered Yesterday


Going to the user's manual: https://www.ameriglide.com/cache/1475784382000/resources/product/615/productDocument/292.pdf
I see that the F code indicates that there is a fault at the motor, possibly corrected by doing a "reset". Directions are in the user manual. The 7 indicates a fault at the "downside safety edge", the little micro-switch on the downhill side of the footplate. See if there is something holding that little projecting piece of plastic that triggers the micro-switch from springing back out to its normal position. Good luck!

Acorn Stairlifts... | Answered 2 days ago


SADLY NUMBERS DO NOT TELL ME WHAT YOU HAVE THAT IS GIVING YOU THE FAULT CODE EVEN GOOGLE SOMETIMES CAN NOT GUESS WHAT IT IS IF ANY TYPOS ARE MADE

Delta... | Answered on Mar 19, 2019


You have to disconnect the power supply for more than 30 sec

Grohe 31251 Blue... | Answered on Mar 18, 2019


If you want to write a dissertation by your own then you have to learn more about dissertation.But i have less idea of dissertation,because I never have to write a dissertation.But if anyone try this by him/her own that is a good decision.You can gather some idea about dissertation from some online providers.You can try this site as well.
http://www.topessaywriting.org/blog/dissertation-help

Proquest, Umi... | Answered on Mar 16, 2019


A little more context would have helped, but I strongly suspect that it is referring to Over Current Protection. That is to say, your inverter has built-in circuitry that will shut it down if you try to draw too much power from it. Think of it like the fuse or circuit breaker on your home wiring.

The OCP for most inverters is re-settable - either automatically (that is, a few seconds after you remove the overload, it starts working again) or manual (a button to press, or you turn the inverter off and back on).

Inverter... | Answered on Mar 12, 2019


I moved you out of computers, to Baldor motor drives.

why not get the free manual and read it first?
Im sure it covers errors.

Inverter Baldor... | Answered on Mar 10, 2019


Sorry, but that's not very specific.

Most USB memory sticks (aka thumbdrives) are "plug-and-play." Meaning you stick them in a USB host socket on a PC (MAC or Windows or Linux, for example) and they automatically get configured and are available for use - just as you would use a computer hard drive.

If that is not happening, then there is a good possibility that the stick is not properly formatted. If it is recognized, but you cannot access the data, then you may need to run the FORMAT utility on your computer. Be aware that this will erase any data currently on the stick.

If you KNOW that you have data on the stick, and it is important to you, then there are data recovery companies that will do their best to access the data (for a fee).

Electronics -... | Answered on Mar 05, 2019


Solar system? Did you mean "solar panel system"?

Unfortunately, some of your other terms are also a bit off. But let's see what we can clarify.

Battery capacity (whether a single, or a bank of batteries) is measured in kilowatt hours. A bank that is rated for 3.55 KwH will produce 3.55 kilowatts for one hour (at least in theory), or 10 watts for 355 hours, or any combination therein. The average home draws about 1.5 Kw (that's *average* - day and night), but much higher during the day (electric lights, appliances, etc. all turned on). So, very roughly, your battery bank is good for a couple of hours of average use - but might handle a home all night with minimal draw.

Sorry, but your final question is not answerable. A 48 volt system is 73 amps to do a full recharge during an hour. But that's too high a recharge rate for most systems. And batteries are not 100% efficient (figure on about 120% - or it will take about 4.25 KwH to charge a battery to 3.55 KwH. So the first issue is how quickly do you want the batteries to recharge.

Panel output varies widely (as does cost). And the amount of sunshine varies not only in duration, but also amount (an hour of sunshine on a clear day in Texas is worth more than an hour of sunshine on a clear day in North Dakota - although North Dakota may appreciate it more <G>). If you want to maintain the batteries, then figure on around 250 square feet of panels - but understand that this answer could be off by a factor of two or more - just depending on conditions.

Solar... | Answered on Mar 05, 2019


PERHAPS BUYING ONE

Electronics -... | Answered on Mar 05, 2019

Not finding what you are looking for?
Electronics - Others Logo

16,705 questions posted

Ask a Question

Usually answered in minutes!

Top Electronics - Others Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

Marvin
Marvin

Level 3 Expert

84027 Answers

Brad Brown

Level 3 Expert

18002 Answers

Are you an Electronics - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...