Office Equipment & Supplies - Page 3 - Recent Questions, Troubleshooting & Support
I have an old Husqvarna Viking 630 sewing machine. I would like advice on how to remove the front cover and availability of electronic control board.
First, you have to remove some screws from underneath the sewing machine. There are one or two small Phillips head screws and one or two, possibly three (I am writing this from memory) larger hex head ones. If you have the back cover off, you can see where the motor screws are: you do not need to remove them. then pry or pull of the large knob. You will notice that the hole in the front that the knob came from is oval, it extends downward from the knob shaft: that allows you to slide that part of the front upwards and off. The left side either comes up or moves to the right to release. However!! Are you sure you need to open this? The three dials you then have access to can be difficult to realign if they separate from their linkage, and there is not much that you gain from this maneuver.
2 days ago
Copystar c2300 error code
You first need to pull the fuser out and manually check that it is running smoothly. More times than not, it will be the fuser rather than the motor.
If the fuser is fine, locate the motor then turn the machine on and visually inspect. If the motor does not run before the code pops up then replace it.
2 days ago
Not finding what you are looking for?