Thank you so much Robert for this Information. I had facing the same issue then as you mentioned the number called on it just be fore 5 minute.. and thy solved it just now within 5 mint....I would like to thank you for helping me....
When a hardware failure happens without warning, you can try the following:
Unplug and Plug-in
When this error message appears. Turn on off power and unplug.Unplug all connected cables.Unplug USB drivers.Remove all printer cartridges.Still turned off, press down power to release all remaining current in the printer.Plug in all cables and USB. Reinstall printer cartridges. Turn power on.See if the error message remains.If error persists, continue to the next method.
Unplug and plug in (2)
Turn off Epson printer and unplug.Disconnect all cables and USB.Wait for 5 minutes until printer cools down.Press and hold the power button for 60 seconds. DO NOT RELEASE.After 60 seconds (DO NOT RELEASE), plug in power cord and hold for another 60 seconds. Release power button. Check if error message still appears.
Clean Mechanic Pad
Turn off printer and unplug.Remove printer cover and casing.Wet tissue with warm water. Wipe cleaning pad.Leave wet tissue for a few minutes on the pad.Remove tissue and leave it to dry completely.Plug in and turn on printer. See if error persists.
If all methods are tried without improvement, you might need to call the customer support or help of a technician.Epson XP-830 is a multifunction printer that has a complex interior hardware. Therefore, a professional help is needed when all methods were tried.
Locate the control panel of your Epson printer. It is usually on the top right-hand side of your printer, near any digital display screen that the printer may have, and where the button used to turn the computer on and off is also located. Find the button marked Pause/Reset on the row of buttons on the control panel.
If I remember right you almost have to break it to get it off it does have two or four screws hat have to be removed. Then you must pry the cover there are plastic tabs holding the cover on. Good luck I have not worked on one of these in years. If I have the typewriter in front of me I’m sure I could do it in no time but I do not.
If Windows 10 v.1903 can not find correct driver for network printter, connect it directly to computer with USB printer cable. After that HP Color LaserJet 2600n driver was found at windows 10 version 1903. I discconected network cable and shutdown the printter before using usb cable
Disconnect and shutdown printter.
Now you can add TCP/IP printter using current drivers.
Run the HP Print and Scan Doctor as Administrator, it should find your printer, select fix scanning problems. After the Windows (WIA) Scan error is discovered, unplug the printer for a few seconds as directed, plug it back in, turn it back on, and restart Windows.
THIS IS A SCAM DO NOT CALL THESE NUMBERS. These phony support numbers send you to criminal call centers where they will install malware, steal ID and/or extort money from you . Only ever use the support contacts from the official company website
To print a test page, you would need to have the power on and the cartridges in the printer. Press and hold power putton and open/close the top cover 3 or 4 times. Also you can try holding the power button and pressing "paper feed" button 3 times, then releasing the power button.
I found a video which kind of shows how to do this. Hope it helps you as well.