Ovens - Recent Questions, Troubleshooting & Support


Google (brand)(B-AP22-7)(manual) without parens.

Ovens | Answered 23 hours ago


Request the diagram directly from Lamona.

Ovens | Answered 24 hours ago


possible when moving ignitor broke

Whirlpool Ovens | Answered on Oct 10, 2019


The asbestos is to prevent a heat insulation but if only there is any shield failure you need to worry. This could have come from within the chamber and so you can get to buy these to be fitted on to the slot covering the magnetron.
To find if there is leak of any radiation you need to have a tester. but if the covers are intact and the door shuts fine then there is no cause for alarm except that asbestos must not fall into the food.

Ovens | Answered on Oct 09, 2019


Belling would be a likely source.

Belling Ovens | Answered on Oct 08, 2019


Hi, Try to replace the temperature control switch. Good luck.

Ovens | Answered on Oct 07, 2019


Possibly, the replacement EOC is defective.

Frigidaire Ovens | Answered on Oct 06, 2019


This means that the Sabbath mode has been enabled. To disable the program, first press and release the Cancel/Off to stop the current programmed bake settings. Then press and hold Settings until Sabbath Mode Off is displayed. See page 14 of the manual for setting the Sabbath mode. The manual is available on the product page: https://www.geapplianceparts.com/store/parts/assembly/C2S995SEL1SS . The current link to the manual is https://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=49-85241.pdf . Most GE oven codes are listed here: https://www.geappliances.ca/en/support/knowledgebase/range-oven-function-error-or-fault-codes . The Sabbath Mode symbol is shown at the bottom of the table.

This mode can be used to set the oven temperature for an extended bake (usually for a low temperature) or a programmed bake. It's used by those who strictly keep the Sabbath but want a hot meal ready when the Sabbath ends.

I hope this helps.

Cindy Wells

GE Ovens | Answered on Oct 06, 2019


This happened to me three times with a brand new oven, they kept coming back and replacing the fuse. I finally made the Kitchenaid dealer replace the whole oven, never happened again.

KitchenAid... | Answered on Oct 04, 2019


I have the same problem with a Kenmore oven. Looks like the oven walls have bent outward.

Ovens | Answered on Oct 02, 2019

Not finding what you are looking for?
Ovens Logo

54,530 questions posted

Ask a Question

Usually answered in minutes!

Top Ovens Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Cindy Wells

Level 3 Expert

6026 Answers

Brad Brown

Level 3 Expert

18108 Answers

Are you an Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...