Pool & Spa - Recent Questions, Troubleshooting & Support


Make sure the piping to the controller is at least 3/4" inner diameter (ID). 1" is better still. 1 HP should be plenty.

Pool & Spa | Answered Yesterday


My EasyTouch was set to "Man. Heat>ON". Once I turned that off, it worked from ScreenLogic.

Pentair Pool &... | Answered 2 days ago


impeller thread is left hand
remove the fan cover at the end of the motor to hold the shaft and undo the impeller in a clockwise direction

Pool & Spa | Answered 3 days ago


It depends what the issue is? If the pump isn't running, it is the pump. Filters do just that, they filter., they can get clogged and reduce flow. You don't say what the issue is or what you have?

Pool & Spa | Answered 3 days ago


switch of the power and isolate the power cord. To uninstall unthread the two inch discharge port union,then the 1.5 intake port union.

Waterway Pool &... | Answered on Jan 14, 2019


If this is an outdoor spa near trees, its almost a guarantee that the impeller is blocked with debris (pine needles can cause this in a hurry)

If the impeller is clean of debris and this is still happening, replace you pressure/flow switch.

Pool & Spa | Answered on Jan 13, 2019

Not finding what you are looking for?
Pool & Spa Logo

27,037 questions posted

Ask a Question

Usually answered in minutes!

Top Pool & Spa Experts

Jay Finke
Jay Finke

Level 3 Expert

1389 Answers

Bill Jordan

Level 2 Expert

373 Answers

David Spradling
David Spradling

Level 3 Expert

9798 Answers

Are you a Pool and Spa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...