Refrigerators - Page 4 - Recent Questions, Troubleshooting & Support


Probably sealed system blockage or leak if compressor is running

Refrigerators | Answered on Jan 10, 2019


Compressor / sealed system problem, or maybe a wiring problem. Hard to say.

Refrigerators | Answered on Jan 10, 2019


Yes it can be fixed but you will need a service technician. You can call Sears service.

Best of Luck,
Robbie ??

LG Refrigerators | Answered on Jan 10, 2019


You might try, repairclinic.com they usually have any repair item needed. Be sure to have your product name and model before you open the site. There should be a tag inside the refrigerator section with this info.

Fridgemaster... | Answered on Jan 10, 2019


Sounds like the evaporator coil is icing up. Once the coil ices up no air can flow through and you essentially have a very large ice chest. The thermostats on these coolers are actually sensing coil temperature not air temperature. I would want to check that it is set properly and that it turns the compressor off and on. If you have an old mechanical thermostat with a knob with settings from 0-9 it should be set on 4-5. Anything higher and it WILL ice up occasionally.

True... | Answered on Jan 10, 2019


THINK THEY JUST LIFT OFF THE SIDE AND NEED UNPLUGGED . WITH WATER TURNED OFF FIRST

Maytag... | Answered on Jan 10, 2019


Hi there
it always on bottom shelf with meat.
Take care all the best

Refrigerators | Answered on Jan 10, 2019


Sounds like contamination inside the controller. Unfortunately this usually means replacing the controller.

LG Refrigerators | Answered on Jan 10, 2019


Have you defrosted it lately? If the freezer is topside then sometimes there is ducting that cools the lower portion of the fridge from the freezer and that can get plugged with ice.

Refrigerators | Answered on Jan 09, 2019


Hi not think you get a works Manual on taking it apart you only get a operating instructions Manual that is not going to help you take any think apart sorry.

Smeg... | Answered on Jan 09, 2019


Since I don't know what does work I am kind of shooting in the dark.
Does the ac heater get hot ?
The spark ignitor is part of the control board. But won't work?
I assume that you have a user manual but I am including a link to download one.
https://www.dometic.com/f6e8a773-69f5-4624-9b35-54e8801da7af.fodoc

Note that there are three fuses. B (12V control) and C (120V Heater) on the control board and a thermofuse L located on the stack.
If L is good and everything else is good there should be 12VDC on J1 and at Fuse B

Dometic RM2620... | Answered on Jan 09, 2019


The motor should cut in and out as controlled by the thermostat. Assuming your freezer is actually working and is cooling down, try the following. If you turn the thermostat down you should hear a click and the motor should stop. If there is no click before it gets to the lowest setting then either the thermostat is faulty (so won't cut out) or the freezer has not dropped to a temperature that is registered by the thermostat (it is too warm). A faulty thermostat is indicated by excessive freezing because it doesn't know when to stop the cooling process. A freezer that is too warm means the cooling process is ineffective and may, for example, require re-gassing.

Electrolux... | Answered on Jan 09, 2019

Not finding what you are looking for?
Refrigerators Logo

171,145 questions posted

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4655 Answers

Marvin
Marvin

Level 3 Expert

83843 Answers

Brad Brown

Level 3 Expert

17804 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...