20 Most Recent Honda 2008 FourTrax Rancher ES Questions & Answers

Check timing, reason it backfired timing out.

All new displays start over just like it was purchased new. You will lose all the mileage readings.

It's probably the Stator winding.

Hi Howard find thd neutral switch on the left hand side near the sprocket it should be a single wire (light green) earth it to the frame or battery and se if the light comes on. If it dose make sure it's in nethral then try to star it. Regards Jim...

the rancher will shift is u put a braker bar on the shiter to manal shift it... i had the same problem but there is a soilinod that needs to be clean or replaced its a constient problem with honda

Be sure the plug at the rear of the engine ic properly attached and clean. It gets knocked off easily.

take the choke out of the carb using a 14mm wrench. The choke is a plunger held into the front of the carb by a plastic nut. Lubricate it and put it back. Be careful not to overtighten the plastic nut.

fuel line plugged, carb needs cleaning, bad gas

I assume it a honda with auto trans,,,, if so needs new oil pump,,, thats what makes tthe trans work it supplies the oil to the trans so it can make presure to work

starter is probly bad and shorting out

out of gas, clogged petcock, fuel filter or stuck carb float. assuming you're getting a spark still of course. that's a whole other can of worms

take off the horn unit power it direct if it works its ok, if not replace, next step wire a small bulb into the horn wires and press the button if it lights the switch is ok, if you have a circuit tester put one end on the battery ground and check for power in the horn wires if their is power there put the lead on battery positive and press the horn button if there is no power their the switch or wiring is faulty

Question edited for clarity, correct order and add maker. Question moved from Cars and Trucks to model category. Service manual https://www.manualslib.com/products/Suzuki-Kingquad-5901790.html ..

https://www.motosport.com/atv/oem-parts/suzuki/2004/eiger-400-4x4-auto/wiring-harness

It seems that the clutch is not disengaging may need a adjustment unless it is hydro drive then I am stumped.