Polaris 2004 Sportsman 500 H.O - Answered Questions & Fixed issues
Tranny works, shifter wont shift the gears. how to fix?
My 2005 Polaris ATP 500 requires I depress the right foot brake while shifting into reverse or down into low range. Perhaps some adjustment on the foot brake to make this work. Also check linkage to make sure it is not binding. Others say if the idle speed is too high, you may not be able to shift. Try shifting with the engine off to see if it goes into the gears, using the foot brake. If yes, try again while at low idle speed.
11/23/2016 3:42:13 AM •
Polaris 2004...
•
Answered
on Nov 23, 2016
•
3,066 views
4 wheel drive will not engage has 12back to rear end
howdie check the vacuum lines and make sure the module is workin should be fuse for it and check for linages are engaging or the transfer case might have broken chain could be that how MAny Km,s does it have ?
3/22/2015 5:40:41 AM •
Polaris 2004...
•
Answered
on Mar 22, 2015
•
467 views
Will not start
Clean and lightly oil the brushes in the starter motor,common prob. they get sticky.
9/29/2014 7:58:56 PM •
Polaris 2004...
•
Answered
on Sep 29, 2014
•
738 views
Why will the cooling fan on my 500 sportsman not turn on .?
I have a 2001 polaris sportsman 500 H.O. I have replaced the fan and the thermial fan switch,and checked the thermostat. Everything is either new or works there are no bubles in the coolant when its running I am running out of opptions . If I unplug the thermal fan switch and plug a jumper wire in the fan will run. I thought the new switch was bad and I tested it and it is good
10/23/2020 1:11:46 PM •
Polaris 2004...
•
Answered
on Oct 23, 2020
•
3,004 views
Carb drain leaks?
This is caused by a bad needle and seat in the carb you can buy a carb kit and replace the needle and seat and it will stop leaking
make sure not to bend the float
7/19/2014 4:59:06 PM •
Polaris 2004...
•
Answered
on Jul 19, 2014
•
717 views
Had new key made on an 04 polaris 700 now it trys
it sounds like your starter solenoid is stuck. Locate the solenoid and check for continuity between the positive and negative poles right on top of it. If there is continuity between the poles in the off position, your solenoid is stuck and probably needs to be replaced.
10/29/2013 8:31:41 AM •
Polaris 2004...
•
Answered
on Oct 29, 2013
•
508 views
Not finding what you are looking for?