How to tighten chain on a kymco atv

I used to have one of the Suzuki quads if I remember right you have to rotate the rear axle forward to loosen and backward to tighten

belt drive ? or chain. ? belt slipping ? sprocket on chain loose?

meter wont change

Installing a hardtop on a 2014 Kymco UXV 700i ATV may vary depending on the specific hardtop you have. However, here are some general steps you can follow:

1. Gather all necessary tools and equipment, including a drill, screws, and any other hardware that comes with the hardtop.
2. Place the hardtop on top of the ATV and align it with the mounting points.
3. Use the provided hardware or screws to secure the hardtop to the ATV. Make sure the hardtop is securely attached and level.
4. Check that all screws and bolts are tightened properly and that the hardtop is securely attached.
5. Test the hardtop to ensure it is properly attached and does not move or shift while in use.

It is recommended that you refer to the installation manual that came with your hardtop for specific instructions and to proceed with caution to not cause any damage to your ATV.

check the pickup coil and the wiring for the shut off switches. if one rubs and grounds itself on the frame it wont spark.

Utube can help u or a manual from ur library. Xplainin it on air has safety concerns...take it slow

clicks, wont crank ??? check ground first, then suspect a bad starter as long as the solenoid and battery are good... a 12v test light will help here

Geez dont keep spending money if your not sure. It sounds like your starter is not throwing in far enough to engage with the ring gear. Please do your hip pocket a favor and get an auto technician to check it before buying a new starter as well. You can also remove the starter and check the gear to make sure its not worn as some are plastic.

1600ml is the Arctic Cat recommended amount BUT if you check the KYMCO manual (the '06 250 is a kymco made for AC) it says the capacity is 1600ml but when you change oil it is 1400ml. This might explain why my oil level always seems higher than it should be. You can check the level with the site glass on the side.

Also on the 250, you also have to change transmission fluid separately. It uses the gear oil NOT engine oil.

i have the same problem