My 400 worked fine and started good with an electric starter and pull rope start. Now when i turn my ignition key to on , my green light does not come on and my starter wont work but i can still hand crank the bike. when you hand crank the unit, the green light come on. Cant get the green light to come on or electric start to work. Any help on [email protected]
Hey Randy,
Sounds like the battery needs to be replaced. Take the battery to O'Reilly, Autozone, Advance Auto and have the CCA, (Cold Cranking Amps) checked..(load test).. this will tell you whether the battery is good or not. When you get a new battery.. make sure the connections are clean and tight..put a little heavy grease on the connections to prevent corrosion. This should fix your problem.
SOURCE: 2001 Polaris sportsman 500 magnum 4x4, speedo dont work
I'm not sure but it might be the sensor on the right front wheel disk
SOURCE: Small, yet aggressive steering jerking on Polaris Xplorer 4X4
had a similar problem-always to the right-2001 polaris xplorer-hub was binding up sligyhtly-checked the oil-none! flushed out hubs and seems to have cured it for the last few months
SOURCE: 97 Polaris Xplorer 500 4X4 rev problem
REPLACE THE CAMSHAFT !!!,,, HAVE A LOOK AT CAMSHAFT , EXHAUST LOBE IS PROBABLY WORE RIGHT OFF....
SOURCE: 2007 Polaris Ranger 500 EFI
If your battery is good then you have dirty or loose connections at the battery or the starter. Quite often this will be on the ground side.
641 views
Usually answered in minutes!
×