You either have the wrong belt or someone removed the shims from the driven clutch.
SOURCE: arctic cat atv problems
If it has in line fuel filter it may be clogged also if tank is located in the rear you may have fuel pump problem. Most that set forward or above engine are gravity fed and have fuel on and off be petcocks with screen type filter in small bowl at bottom which can be removed and cleaned. The screen will above bowl threads in the petcock. Hope this helps,
SOURCE: Arctic cat xtx 700 2010 Jumps when you take off
Clutch wear (springs) or the belt needs replacing.
SOURCE: 2004 arctic cat 500 4x4 starter turns doesnt engage starts with pull cord
1. Never jump start an ATV, Motorcycle, UTV..etc from a automobile! The amperage is TOO high, you can damage a lot of expensive electrical components!! ..very quickly!
You cannot home trouble shoot without a new battery or fully charged battery with good solid clean connections!!
2. Have the battery tested or simply buy a GOOD new one!
3. Does the starter spin at all? Is there a clicking noise when you push the start button? No - solenoid is bad(?) . you can check this by jumping the two large connectors on the solenoid... A good screwdriver works well...(CAREFUL - SPARKS WILL FLY!) If the starter works while jumping, the solenoid is bad - just replace it (disconnect battery while replacing).
4. If the start spins while "jumping" and nothing happens the starter may need rebuilding if the new battery/fully charged battery/jumping solenoid does not expose/solve the problem.
Do this and repost.
Steve
178 views
Usually answered in minutes!
×