Polaris ATV Logo

Related Topics:

J
Joe D Posted on Mar 21, 2019

Have a 2012 ranger 400 4x4 not engaging front differential

Have power to it still don't work how do I fix magnet in side

1 Answer

wraithester

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

  • Contributor 4 Answers
  • Posted on Mar 22, 2019
wraithester
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Joined: Jan 31, 2010
Answers
4
Questions
2
Helped
763
Points
16

Check wiring under vehicle going to diff for breaks

Testimonial: "have power to it still don't work can I fix magnet in it"

3 Related Answers

Anonymous

  • 1 Answer
  • Posted on Sep 30, 2008

SOURCE: hummer h2 transfer case

Only way for this to happen on an H2 (AWD) is for something to break rearward of the lockup hub. Take a look at the splines between the intermediate shaft and centerdifferential or even the teeth on the forward sun gear and/or stepped pinion on the center diff.

As long as you have the t-case torn down for repair be sure to upgrade to the new aluminum mode fork (production upgrade to old plastic forks thru end of 2007 or so). You should also upgrade the rear half of the housing to the 2008 version which has a pressed-in rear prop bushing (better bushing and is also replaceable.

Ad

Anonymous

  • 33 Answers
  • Posted on Jan 21, 2010

SOURCE: front differential leaks how do i fix it

the generally leak from the cover..
have the cover replaced and there is a gasket you can buy at a low cost + you might want to add some high temp silicone before between the gasket and the cover...

hope this helps.

Anonymous

  • 178 Answers
  • Posted on Nov 20, 2010

SOURCE: how do i manually engage the front differential on

there should be a diaphram under the battery that connects to a cable this is vacuum operated but you can also pull back on to engage the front diff.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a 2013 Polaris Ranger 800 side x side 4x4. I turn on the engine, lights come on. I push the brake, the solenoid engages, the starter gets power. Engine does not turn over.

If the soleniod engages and no starter motor run.....the solenoid is bad or bad starter motor brushes.....do not rap on the starter ......the permanent magnets are subject too damage ......replace the starter ..........
Oct 22, 2020 • ATVs
0helpful
1answer

Where to find the serial number on polaris ranger

hi.
this is all i can find on the internet about it.
Where to find serial number on Polaris Ranger? Whenever corresponding about a Polaris RANGER utility vehicle, be sure to refer to the vehicle identification number (VIN) and the engine model number and serial number. The VIN can be found stamped on the lower frame rail on the front LH side of the vehicle (see Figure 1-1).

2011-2012 RANGER 800 XP / HD / CREW / 6x6 Chapter 1 - Asap911

asap911.com/wp-content/uploads/2012/.../2012-Polaris-Service-Manual-Chapter_01.pdf Search for: Where to find serial number on Polaris Ranger?.

how to find vin number on polaris ranger Google Search
Oct 31, 2017 • ATVs
1helpful
1answer

2012 ranger xp 800 won't go into 4wd. Light comes on like before but stays in 2wd

check fuses wiring and connections ---check for power to the actuator --if good actuator can either be stuck which some lube can help or burnt out and will need replacement
0helpful
1answer

I have a 1999 Polaris Ranger 6 x 6 what engages the front wheels transmission or front gear box

I'm in the UK and not familiar with your particular vehicle..
However, the front gearbox as you call it is probably a transfer unit/case. This transfer case takes power from your auto transmission and transfers it to the front wheels.

You can remove the front propshaft (drive shaft) from the transfer case/front differential and make your vehicle 2 wheel drive. This, supposedly, gives you better mpg.
Apr 21, 2016 • Polaris ATV
0helpful
1answer

Where can I find instruction on how to replace rear prop shaft yoke and u joint on a 2012 Polaris ranger 500 side by side.

Rear Drive Shaft - YouTube

? 1:55
www.youtube.com/watch?v=WpRjFnBf0ZQ
Dec 1, 2012 - Uploaded by Charles Humphrey
Is this excessive play in the rear drive shaft where it connects to the ... Published on Dec 1, 2012 ... It was the ...

Polaris Sportsman propshaft u-joint replacement - YouTube

? 22:29
www.youtube.com/watch?v=i-yqEJRVgo4
Apr 30, 2013 - Uploaded by SeanBoburk Changing the propshaft U-joints on my 2006 Polaris Sportsman500 X2 ... Thanks yours tips help me ...

0helpful
1answer

(fount) will not lock in on all four wheel drive

power supply to the magnetic hubs not reaching hubs, check power supply line to front hubs
0helpful
1answer

I have a 2002 Polaris Ranger 500 the 4x4 button

There is a big serrated washer that engages the plastic cogs to make the 4wd work.Either the magnet is not pulling in the washer or your white plastic cogs are broken.I have had my 2005 700 apart.If you are mechanically inclined it will take a a good 1.5 hrs to get it all apart to inspect it.
Sep 29, 2014 • ATVs
1helpful
1answer

4x4 locking up when in 2 wheel drive

sounds like u need to change your hub fluids and or clean the meatal rings in the hubs so the electro magnets will engage your hubs efficiantly
Not finding what you are looking for?

380 views

Ask a Question

Usually answered in minutes!

Top Polaris ATVs Experts

john h

Level 3 Expert

29494 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Polaris ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...