Question about Polaris 2009 Ranger RZR 800 S

Open Question

What can I check to fix a locked engine. My primary clutch went out on 08 rzr 800 n caused engine seizure

Posted by on


2 Suggested Answers


6ya staff

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017



  • 52 Answers

SOURCE: What causes my 2008 polaris rzr 800 efi to back fire when I release the throttle

First thing first chang the plugs that model you have is bad about fauling plugs do to not allowing motor to warm up even if you were moving it five feet from were it was setting and don't matter if you just replace them early in the year, if it is cold this will happen with out ? So do this first.if that don't fix the problem Ok on your intake tube between the air box and the throttle body should be a small sensor mass air it has a small screw that holds the adjustment for it loosen the screw and and turn it counter clock wise just slightly tighten back and start bump throttle keep repeating the process untell you have a quick throttle response . Be sure to shut off and restart each time you move it keep your eye on the check engine light when you have it right the lite will stay out .good luck

Posted on Feb 06, 2019


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My husband removed the engine and now he doesn't remember how to reinstall it.

Your husband really needs a shop manual. Everything is explained there.

Oct 28, 2015 | Polaris 2010 Ranger RZR 800

1 Answer

Starter spins but don't engage and won't start please HELP!!!! This is on a Polaris RZR 800s 2013

Check to see that the pinion gear of the starter is hooting out and engaging the flywheel.
And if it is working it is possible that you have missing tooth/teeth on your flywheel and the starter cannot turn over the engine because of that.

Sep 18, 2015 | Polaris 2011 Ranger RZR 800 S

1 Answer

2013 800s rzr misses at low speed

Solid state ignition has a capacitor that must charge and when the right time comes a SCR will dump the charge into the coil to make a spark. There is a minimum voltage that is required to trigger the SCR and at low RPMs that normally is close to being not enough. Most likely you will need to change out that CDI ignition or check the coil in the magneto, it may need to be adjusted closer to the flywheel.

Sep 20, 2014 | Polaris 2013 RZR S 800 Orange / White LE

1 Answer

2013 rzr s 800 fan just quit...we just easy ride and maitance it well kept up....don't understand

Common problem,if you have power going to the fan,you need to have the fan removed,the brushes cleaned,lightly oiled and tested.

Jan 03, 2014 | Polaris 2013 RZR S 800

1 Answer

When my 2012 polaris sportsman 800 is in gear and i press the accelerater it dose not move. I tried putting it into high, low, and reverse and press the accelerater it dose not move. The primare and the...

If you have a primary and secondary clutch, and your ATV still fails to move with proof that they are working, my best advice would be to check the pilot shaft and the gears for excessive wear. Even in new products, the case of excessive wear can be well known, and it would be wise to take it back to the dealer if you continue to have the problem.

Nov 05, 2013 | Polaris 2012 Sportsman 800 EFI

Not finding what you are looking for?
Polaris 2009 Ranger RZR 800 S Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Polaris ATVs Experts


Level 2 Expert

106 Answers

john h

Level 3 Expert

22486 Answers


Level 3 Expert

85222 Answers

Are you a Polaris ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides