Sorry the Flywheel, on a Kawaski Mule 610 removal and installation?

Front right side by filter.

Open fill cap and oil level should be full.

Kawasaki MULE 610 44 Service Manual

ground wire from the switches to the CDI is broken somewhere.

Kawasaki Mule Update - YouTube

? 2:16
www.youtube.com/watch?v=Fw_jeQUU6Hw
Jan 25, 2013 - Uploaded by Penguinboy1995
solenoid is reading battery voltage and the constant hot, it is not sending the 12 volts from the switch to the ...

first off secure the buggies tyers with chocks either a brick or some wood blocks then proceed to jack up the tyre and axel you would like to remove - remove the tyre proceed to remove the hub once you have established where the bolts _ cotter pin etc are located

remove the wheel then undo the big nut in the center then remove the brake caliper then remove the big nut and the hub will come off !

Kawasaki mule 610 new battery but little to no power to solenoid. Fully charged starter makes rapid clicking noise. When attacked to battery jump starter it will start. Mule was running excellent for 2 weeks with new battery. I was told by kawasaki technician it was ignition. Nope thoroughly skimmed inspected wires and see nothing wrong. Technician told me different second time, it's now the starter replaced starter ($450) and still no results I'm at a loss

Put voltmeter to OHMS should test the wires from the Regulator and if you get and reading there is a short in the Stator which is behind the Flywheel.

Hey Dennis, there is no way to tell what part number(s) you need.. this is not a complicated repair, but does take some knowledge.. if you are not very good, mechanic wise, I would find a qualified professional to help with it...it has to be RIGHT,, or it will break again..