Question about Yamaha 2004 Big Bear 400 4x4
Sounds like the carb could use a cleaning and setting by a professional...install a new plug and a new air filter.. AFTER the professional carb cleaning and setting.,,do this and repost
Posted on Jun 11, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
i'd say the carb is gummed up especially the pilot jet (#16158) in this pic of the USA carb. may have to remove the carb & bowl and then remove the pilot jet (w/ flat head screw driver) and clean out the tiny holes.
the carb slide is installed backwards (turned 180 degrees). its #16025 in the pic. i've done this before on my daughter's XR70 and Z50. you'll know if its this when you move the choke lever, RPMs increase and decrease.
hope this worked for you and was fast enough.
Posted on Feb 06, 2009
SOURCE: yamaha big bear no spark
I'm not familiar with all quads and all the kill switch locations. Does it have a tip-over kill switch? Is it working? Is the quad in neutral? Is the neutral light on? Many engines will not spark if the neutral light is not on. Are the headlights off when starting?
How good is your battery? A low battery can kill spark. Test for spark by grounding the threads of the plug against the cylinder. Have a friend kick the bike while you watch for spark. Assuming no spark, then check all the kill switches with an Ohmmeter to be sure each switch is working properly. Sometimes a switch goes bad. Try disconnecting all kill switches then check spark.
Check the wiring harness, even under the gas tank and seat. Are all the connectors clean and with a tight connection? Any abraded wires? Check the ignition switch also. The switch can go bad as well. Are the flywheel coils good > is the battery getting a charge?
Still no spark? If CDI then get it checked.
If points then file or replace them along with a new condensor and reset the gap then time the engine. >> I hope this helps.
Please rate this answer. Thanks trsrhntr!
Posted on Apr 03, 2009
Tips for a great answer:
Jun 22, 2016 | ATVs
May 10, 2015 | Yamaha 2005 Big Bear 400 4x4
Dec 30, 2014 | ATVs
Jul 13, 2014 | Polaris 2011 Sportsman 400 H.O
Sep 08, 2013 | K and N Yamaha Big Bear Yfm350fw Air...
Apr 04, 2017 | Yamaha 2005 Big Bear 400 4x4
May 13, 2017 | Yamaha 2005 Big Bear 400 4x4
Sep 24, 2010 | K and N Yamaha Big Bear Yfm350fw Air...
Mar 02, 2018 | Yamaha 2004 Big Bear 400 4x4
1,439 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: