Alpine Cars & Trucks - Page 7 - Recent Questions, Troubleshooting & Support


Can be a fuse, but if only the dash lights are out, is probably the dimmer control. Most folks leave the setting as is for a very long time, which can cause a dead spot in the rheostat. Try adjusting it a few times.

Cars & Trucks | Answered on Jan 24, 2020


Run the A/C on max for a few minutes then feel the low pressure line the low pressure line is the larger of the Two. If the line is freezing cold check the blend door to see if it's stuck or broken. If the line is warm connect gauges then check pressure switch and compressor. I hope this helps. Take care.

Cars & Trucks | Answered on Jan 24, 2020


All shredders have a direct drive from the motor to the gears and to the cutting blades. Strip the case off, grease and lubricate gears, bearings and pins. Most of all, use cutter lubricant.

https://www.manualslib.com/manual/388985/Ativa-X1800.html

Cars & Trucks | Answered on Jan 23, 2020


if youre lucky from nissans website

Cars & Trucks | Answered on Jan 23, 2020


Usually a failed temperature sensor on the engine, but could also be the wiring or your instrument cluster.

Cars & Trucks | Answered on Jan 23, 2020


https://ibb.co/sKtr3zt

Click on the link, the info is for 4t40e transaxle. The info says the transaxle holds 6.9 quarts, but, you can't go by that. How much fluid did you drain out? If you over fill or under fill, that is your responsibility. good luck

Cars & Trucks | Answered on Jan 23, 2020


Registered. The 6 Cyl has two sensors. The front one is located on the left side of the engine block just behind the AC compressor. The rear sensor is located on the left rear of the block below the starter.Jan 5, 2020
www.trailvoy.com > ... > OEM Issues

Where is the knock sensor located??? ' Chevy TrailBlazer ...images
https://www.google.com/search?q=06+trailblazer+4.2+knock+sensor+location

Or MAF or MAP sensors if on the intake itself.

Google
year make model sensors
and you find a diagram of them all.

Cars & Trucks | Answered on Jan 23, 2020


On every car ever made since car history began??

Google

year make model remove door panel

Normally, remove all screws including those hidden behind covers, then use a wide blade screwdriver to lever off the studs starting at the bottom edge.

Cars & Trucks | Answered on Jan 23, 2020

Not finding what you are looking for?
Alpine Logo

Family Lines

47 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Alpine Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Vernon Taylor

Level 3 Expert

6030 Answers

john h

Level 3 Expert

22486 Answers

Are you an Alpine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...