Chrysler Cars & Trucks - Recent Questions, Troubleshooting & Support


Tip & How-To about Cars & Trucks
Resetting a Vehicle Anti-Theft System
This is how you reset an anti theft system if you have the anti-theft light on, or your car is cranking, but you have no spark.

Doing a full reset of the anti-theft system.

Disconnect both battery leads for at least two hours.
Hold the negative and positive leads together for 5 minutes to fully discharge any power.
Put the key in the ignition, but not turned on. VERY IMPORTANT!
Connect the positive lead.
Connect the negative lead in one swift movement.
Wait 15 minutes for the system to fully reset.

Posted by Andrew... on Jan 14, 2018

Chrysler Cars &... | Answered 4 hours ago


yes...the console cover "plate" is a pop-off style..gentle persuasion w/a flathead screwdrive is all that is req'd..be sure to remove the shift knob 1st-there's am Allen wrench set screw holding that on, cuz that "plate may need to lifted off the shifter to have enough room

Chrysler 300M... | Answered Yesterday


1. try to check the cable connected to your dvd player. make sure it doesnt loose and connected well
2. make sure that your dvd is well / can be used.
3. try to run another dvd to your dvd player. compare the result.
thanks.

Chrysler Cars &... | Answered 2 days ago



Hi buddy,
Would suggest ya to try some online manuals.. if u know a good website then go ahead or otherwise try reliable-store.com
It's great for automobile repair and the people are also very helpful..
All the best:)

Chrysler Cars &... | Answered on Dec 05, 2019


DEPENDS ON WHICH ONE YOU ARE WORKING ON AS TO WHAT IS IN THE WAY OF IT

Chrysler Cars &... | Answered on Dec 03, 2019


There are lots of issues with the multifunction switch for Chrysler

2012 Chrysler... | Answered on Dec 02, 2019


Chrysler Pacifica P0131: O2 Sensor Low Voltage (Bank 1 -Sensor 1) P0131 is a common OBDII code that occurs in many vehicles, including the Chrysler Pacifica. It is letting you know that there is an issue with the wiring or harness going to the sensor, or the sensor itself is bad.Feb 1, 2019

Chrysler Pacifica P0131: O2 Sensor Low Voltage (Bank 1 ...


https://www.700r4transmissionhq.com > p0131-chrysler-pacifica

Chrysler Cars &... | Answered on Dec 01, 2019


The EGR valve is located at the rear of the engine, on the right side. The wiper arms, cowling and wiper transmission assembly all need to be removed to access the EGR.

Chrysler Cars &... | Answered on Dec 01, 2019


low voltage o2 sensor bank 1 sensor 1 the computer registered a fault that the o2 sensor had lasted over 2 minutes problem faulty o2 sensor --short in sensor/wiring--short in wiring circuit sensor 1 is the sensor before the cat converter

2004 Chrysler... | Answered on Dec 01, 2019


Sounds like loose wheel bearings and front struts if it has them.

1999 Chrysler... | Answered on Nov 28, 2019


power steering fluid or dextron 3 trans fluid

2001 Chrysler PT... | Answered on Nov 28, 2019

Not finding what you are looking for?
Chrysler Logo

49,842 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...