Ford Fiesta - Popular Questions, Answers, Tips & Manuals
2008 1.25 Zetec. Why do clock/date & trip counter zero approximately 30 minutes after ignition is switched off?
first car?
that all newer cars have this key off feature.
and now KEY less? starts? (as in no metal key slot?)
the owners users guide in the glove box covers this.
titled, power off accessory delay feature. 10 to 30 minutes mostnewer cars have this A FEATURE.
if inside car see this delay timer end, open driver door power off delay ends. (proof it is this)'
this feature prevents draining car battery dead and now stranded with hug towing bill.
I can see all there in totality, to just be sure.....
or is this. (if it loses time on clocks)
a fuse is blown. stand-by memory fuses.
cars have many, now. for each computer on board.
check all fuses.
can I assume car drives great?????
and scan tool scans show no DTC errors>?
some newer a cars now have newer feature to bring back , KEY ACCESSORY mode. now missing with autostart buttons no metal key, so read the users guide for that. (some have this longer start button push rule)
what's next clap on , clap off cars?
I need the torque settings for a Ford fiesta 1.4 2010 for the main bearings the head bolts and big ends
Here are the torque settings for a Ford Fiesta 1.4 2010 for the main bearings, head bolts, and big ends:
Main bearings
- Main bearing caps: 1st stage - 7 Nm, 2nd stage - 16 Nm
- Main bearing bolts: 45 Nm + 90°
Head bolts
- Cylinders 1-3: 2nd stage - 30 Nm + 90°, 3rd stage - 80 Nm + 180°
- Cylinder 4: 2nd stage - 25 Nm + 90°, 3rd stage - 60 Nm + 180°
Big ends
- Connecting rod cap nuts: 1st stage - 22 Nm, 2nd stage - 40 Nm + 90°
Please note that these are just the general torque settings. The exact torque settings may vary depending on the specific engine and vehicle. It is always best to consult your vehicle's service manual for the correct torque settings.
Here are some additional tips for tightening the torque settings:
- Use a torque wrench to ensure that the bolts are tightened to the correct torque.
- Tighten the bolts in a star pattern, working your way from the center out.
- Do not overtighten the bolts, as this can damage the engine.
2012 Fiesta. Why don't wipers and power door locks work?
https://ibb.co/cNnLhdZ
Click on the link for diagram
You can check those fuses at the top, they go hot with key on. At the wiper motor, you can see hi and lo speeds and the wire colors, that's voltage. That solid black wire is ground. You might be able to take wire connector loose from motor, use jumper wires off the battery for voltage and ground to motor to see if it will run? You might should use an inline fuse, just in case. Do testing before you replace anything. Also, the are trouble codes for wipers, manufacturer specific codes.
What is kwp 2000 mean on my ford fiesta
Where did you come up with that ?
Keyword Protocol 2000
Keyword Protocol 2000, abbreviated KWP2000, is a communications protocol used for on-board vehicle diagnostics systems. This protocol covers the application layer in the OSI model of computer networking. The protocol is standardized by International Organization for Standardization as ISO 14230. KWP2000 also covers the session layer in the OSI model, in terms of starting, maintaining and terminating a communications session.
Not finding what you are looking for?