Ford Freestar - Recent Questions, Troubleshooting & Support

You don't specify for what ?

Question edited for clarity and typos. 'year make model' in order. Question moved to model category. Duplicate post deleted. Refresh Page to see your question. Passenger side rear bank closest to windshield. See the diagrams https://www.google.com/search?q=04+ford+freestar+3.9+firing+order ..

3 leg hub puller when they are stubborn. Videos. https://www.google.com/search?q=2005+Ford+Freestar+4.2.+How+to+replace+left+rear+hub ..

The code is on the fuse box under the dash near the hood release. On my van there are two bar codes on a sticker attached to the fuse box. Under the first bar code, on the right side is the 5 digit code (bring your glasses the numbers are really small). After you get this code, just search the internet and there are plenty of forums on programing the keyless remote and also adding your own unique number to the key pad entry.

Good Luck

Please let me know if you have more questions, and thanks for using FixYa.

Mine was the fuel pump there's a valve on there I think it's a pressure sensor built on to the fuel pump 03 Ford ranger 4.0 I just put the new fuel pump in 3 months ago this is my third fuel pump there's three to four things to check the canister pressure sensor and the other sensor underneath the hood the SUVs in the Ford expedition has the same setup just about

cam sensor will make a squealing noise i have an 05 freestar 4.2l take the top of the sensor off put 2 drops of motor oil in it and reassemble that will take care of your noise .

Hello, If you have not checked your Inertia switch it shuts off the fuelpump and may need to be Reset. It should be in the RH side of the jack compartment. You just push and hold a button on the switch and then the fuelpump should work.

The Inertia switch is a safety device and can trigger when a door or hatch is closed hard enough to simulate a crash. You also can have a Relay in the Powerbox which may be labeled. Try the Inertia switch first and if it does not help, then change the Fuelpump Relay.

More than likely your crankshaft will be as bad as the rod insert.

Question edited for clarity. Question moved to model category. There is help in the link. https://www.google.com/search?q=2005+Ford+Freestar++Why+is+the+car+hard+to+shift+on+take+off ..

A Pro Grade (5k), or a least a GOOD (1k) Scan Tool will tell you exactly where the trouble is.

http://airbagcode.com/ford-freestar/81

Ford Freestar (2003 - 2007) - fuse box diagram - Auto Genius

https://www.autogenius.info > ford-freestar-2003-2007-... Jul 8, 2018 - The fuse panel is located below and to the left of the steering wheel by the brake pedal. Ford Freestar - fuse box diagram - passenger ... ..

Is the security light flashing ? PATS - fords anti-theft system disable the starter from working if has a problem .

Sounds like one of the doors are not closing all the way!If not closed completely there is not good contact at the switches making it seem like a door is partly open when breaking! Check all doors for tight close and adjust or repair. Including rear hatch !Also look at the information center on dash (if still lights up) it should say which "Door is Ajar" when the beeping\lights flashing is occurring.

try auto zone and if you buy the bulb from them they will print out a diagram of how to install

This code will not cause a no start. Does the engine turn over but not fire or what?

En qu? parte se encuentra Ford freestar 2004

Try you tube !

does your messages center totlly no funtion? check the message center switch, to remove the message centwr swich, press the retaining tabs and remove the switch through the back of the instrument panel