Mercedes-Benz Cars & Trucks - Recent Questions, Troubleshooting & Support


Hi:
Most brake light switches are mounted to the upper area of the brake pedal arm, and are held in place with a pin or clip.

Mercedes-Benz... | Answered on Nov 09, 2019


A couple of different possibilities here but this is a typical problem when it comes to the MB cd changers. Before ruling the cd changer bad, check the spring settings on the sides of the changer. Make sure they are in the 'H' position since it sits in the glovebox. The Mercedes cd changers don't have a reset button. 95% of the time its the cd changer that is bad when this scenario happens. Its caused by a linkage that gets knocked out of place internally of the cd changer. Also try not to use burned or homemade cd's as they can also cause the cd changer not to read the discs anymore.If your cd changer is brand new or a factory rebuild then the dealer should change it out no problem since MB cd changers are known for this problem. Also the version coding needs to done to configure the D2B fiber optic ring properly.

2001... | Answered on Nov 03, 2019


I would say your headlights have burned out. Often times people will lose one and not notice until the other one also burns out. If you can get someone with a voltmeter to check at one headlight for 12-13.8 volts while the headlights are switched on. If voltage is present at the connector then the bulb is burned out most likely. I've seen this many times. Your high beams probably work.

Mercedes-Benz... | Answered on Oct 29, 2019


WHAT SERVICE INTERVALS YOU REFERRING TO SERVICE A OR SERVICE B OR THE 60000 MILES SERVICE.

2006... | Answered on Oct 16, 2019


Car is 25 year old. Some wire/wires are shorting with each other or the battery. For doing a Battery drain test known also as Parasitic Draw test.
You need a good Multimeter, probes and Fuse puller. follow the link given below for You Tube and similar ones. It is very time consuming.
How To Perform a Parasitic Draw Test - EricTheCarGuy

I’m happy to assist further over the phone at https://www.6ya.com/expert/uttamjeet_2f3adc18600f8ede

Mercedes-Benz... | Answered on Oct 09, 2019


Unseen things can sometimes brain your battery. A trunk light that doesn't go off when the trunk is closed. Open the trunk and touch the bulb quickly, it should not be hot yet. If it is it's stuck on. The same goes for the glove compartment light.

There could be a problem with the alternator or even a battery that just won't hold a charge as opposed to an actual power drain. Fully charge the battery and then disconnect it for the night. Next morning reconnect it. If the charge is holding it will start just fine. If it doesn't then your battery is suspect.

2003... | Answered on Oct 09, 2019


You will need access to an OBD II Code reader,this will determine what engine sensors are faulty by providing you with a fault code,once you have the code and determine what sensor is at fault you can them replace the sensor and using the OBD clear the fault code/s

Mercedes-Benz... | Answered on Oct 04, 2019


You can try out some guide from here reliable-store. com

they also provide live chat feature for instant help and it's very useful

Mercedes-Benz... | Answered on Oct 02, 2019


Assuming you didn't drill the lock, it would have been best to access the interior of the vehicle (if not deadlocked, breaking in would be relatively simple) and current could be supplied to the vehicle via the cigar lighter or from under the hood by connecting to the battery circuit in order to use the in-car trunk release if fitted.
A way into the trunk can usually be found by removing the rear seat or hooking the keys using a fishing tool through the armrest aperture if there is one.

Mercedes-Benz... | Answered on Oct 01, 2019


assuming it is right hand drive the logical place for the hood release is on the left side of the passengers seat just under the dash http://www.mercedesmedic.com/wp-content/uploads/2016/02/open-hood-mercedes-benz-release.jpg

Mercedes-Benz... | Answered on Sep 25, 2019


You need to read the codes. I had a plugged cat that turned off all the cylinders on one side of the engine.

Mercedes-Benz... | Answered on Sep 24, 2019


I recently had my engine replaced in my 2002 grand marquis 4.6 with a 2009 crown Vic 5.4 engine and was running fine until I broke my ignition and tried to replace it myself I bought a new ignition switch didn't work so I bought a steering column and still won't start what do I do

Mercedes-Benz... | Answered on Sep 24, 2019

Not finding what you are looking for?
Mercedes-Benz Logo

24,879 questions posted

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...