20 Most Recent 2009 Buick Enclave - Page 6 Questions & Answers

per Gates Rubber Co. website, this is the routing diagram for a 2009 Buick Enclave V-6 3.6 L engine (i had to create an image from their book) the circle numbered 1 OR 2 will be the tensioner that you will need to release to get the belt on (you can usually use a ratchet with a short extension bar or socket to grab it to turn it away from the center) try VERY hard not to gall or damage the pulley or you will HAVE to replace it.

per Gates Rubber Co. website, this is the routing diagram for a 2009 Buick Enclave V-6 3.6 L engine (i had to create an image from their book) the circle numbered 1 OR 2 will be the tensioner that you will need to release to get the belt on ( you can usually use a ratchet with a short extension bar or socket to grab it to turn it away from the center) try VERY hard not to gall or damage the pulley or you will HAVE to replace it.

The easiest place for you to tap the Dome light power would be at teh fuse panel where the fuse is located. The ground for that to work is the little switch in teh door jam near the hinges. The problem you may run into is the dome light coming on when you activate the switch to turn those LED lights on. Your going to tap the power wire direct and put the switch to turn them on controlling the ground unless you want them to work at the same time the dome light does in which case I would tap the power line direct and then run an additional wire to tap the switch in the door. A better option, at least to me, would be to tap power off the lighter circuit and control that with the switch then you could ground anywhere you have a good ground.

so where is the noise coming from? Front? rear? right? left? only when braking? moving? turning? We are not there to hear it, so must rely on you.

the wheel is most likely locked, jiggled the steering wheel and turn the key until the steering wheel comes free.

You need a new ignition switch lock cylinder.

Did you check the fuses? Under the dash and under the hood!

Read the owner manual. Note that 2008 & 2009 manuals have incorrect information. Locate 2010 Enclave on internet. It has correct description and bulb number. Bulb is a 7443, NOT a 3157.

I have a 2009 Buick Enclave...a few months ago out of the blue, my blue tooth does not work...the phone rings in, but when I press talk on steering wheel...it goes quiet...it's connected but they can't hear me and I can't hear them....the phone worked fine, then one day it just started acting goofy...any suggestions? I have deleted, paired, unpaired!

Common on any vehicle, exhaust pipe

Press the onstar button and they will check the codes for you and tell you what the problem is for free.

Probabley just the bulb

behind the passenger seat under a floor panel