2009 Mitsubishi Outlander - Page 2 - Answered Questions & Fixed issues

try cleaning the remote also change the battery in the remote

2009 Mitsubishi... | Answered on Apr 15, 2012 | 522 views

From what I can tell with the information you provided, this lamp will be illuminated when the automatic transmission fluid temperature is excessive.

Also without knowing which engine you have, (apparently each one comes with it's own problem with this light) I would advise you to swing into your dealer and just ask them to take a glance at it. It could simply be that the brakes need replacing, or even or more likely the abs sensor is wearing out.

In the owners manual, they should discuss the exact process to reset the light. it may not reset if you hold button for 10 seconds, when they say hold for 5 seconds. So, if you think that is not the case and you have correctly attempted to reset the light, stop by your dealer.

Good Luck and Happy Motoring

Hey Dont Shoot The Messenger

2009 Mitsubishi... | Answered on Mar 03, 2012 | 868 views

A fault has been detected. The best way to find out what it is would be to hook up a shop scanner. It may just be soemthing simple like a wheel sensor but a scanner would show the data that all the sensors are putting out and comparisons and test can be done.

2009 Mitsubishi... | Answered on Sep 27, 2011 | 179 views

I'am not sure but i had a corvette hat needed reprograming. ...disconnect the battery for about 5 min...and reconnect and try the new key....Its worth a try.. goodluck ...

2009 Mitsubishi... | Answered on Jul 17, 2011 | 156 views

battery is going dead

2009 Mitsubishi... | Answered on Jun 08, 2011 | 342 views

i sugest you follow the user manual while dealing with such delicate interior components.

2009 Mitsubishi... | Answered on Dec 29, 2010 | 93 views

Yes, you can get them from your Mistubishi dealer. I bought a copy on CD. It's key coded tho, so you'll have good luck getting a piratted copy to work.
Around $220. It's the Full service manual. Not very user frendly tho, as it's for trained tech folks, but better than nothing.
If your Mitsubishi dealer can't find it, they're lying to you. Tell them it exists, and you want a copy!

2009 Mitsubishi... | Answered on Nov 30, 2010 | 1,540 views

Turn on the key but do not start it. Rapidly depress the gas pedal three times. That should reset it for u. J.

2009 Mitsubishi... | Answered on Sep 23, 2010 | 1,048 views

I mounted the dealer crossbars onto my 2010 Mitsu Outlander. The drag noise is VERY loud. It sounds like I have a window open and worse they whistle as well. Any ideas how to fix this?

2009 Mitsubishi... | Answered on Apr 20, 2010 | 509 views

Try this,,turn the key on ,wait 10 minutes,then turn the key off,then right back on,do this three times,a total of 30 minutes,this should reset the key fob,if this is the problem.

2009 Mitsubishi... | Answered on Oct 26, 2017 | 1,906 views

check all fuses

2009 Mitsubishi... | Answered on Apr 03, 2010 | 50 views

I am going to assume your question is about entering a code to make the radio work? If so here you go... Some radios have an antitheft feature built in. When the power is disconnected (like in replacing a battery or if the radio was removed or stolen from a car) then you have to enter a code to activate it. Call the dealer and ask if they can help you with the code and procedures. Your owner's manual should have the procedure listed in it but the code should have been in the papers that came with your car when it was new. Again the dealer is your best bet. They will need your vehicle VIN and maybe even the radio serial number. There are some web sites that offer to sell you radio codes but I have had good luck with the dealers giving me them free.

2009 Mitsubishi... | Answered on Feb 28, 2010 | 134 views


2009 Mitsubishi... | Answered on Feb 28, 2010 | 299 views

A 09 OUTLANDER without key less entry,has a small screw back of key
With keyless,remove emergency key,lever remote open with small screw driver

2009 Mitsubishi... | Answered on Feb 19, 2010 | 1,635 views

If it's not in writing signed by both parties, you have nothing. Sorry.

2009 Mitsubishi... | Answered on Feb 17, 2010 | 44 views

royal purple full synectic

2009 Mitsubishi... | Answered on Feb 04, 2010 | 338 views

Could be 3 things

1 low gearbox fluid or the system needs to be bled through.

2 the slave cylider for the auto gears has gone wrong and may need replacing although the year of the car this would be unusual.

3 the torque converter in the gearbox might have gone, all 3 of these would cause this issue.

Go for the cheaper ones first check the fluid, and ensure there is no air in the system.

Hope this helps. auto box's are a funny thing and it would have to be one of these 3 things unless the gearbox has gone, but again thats not very likely on a 2009 car.



2009 Mitsubishi... | Answered on Jan 31, 2010 | 438 views

When in doubt, if it's a block heater, I usually look under engine block for cord attached to heater, then follow it forward. A quick call to dealer may save a lot of aggravation though, I'm sure they will tell you.

2009 Mitsubishi... | Answered on Dec 31, 2009 | 520 views

if you type in this address,it is a tip I posted it will help you,

2009 Mitsubishi... | Answered on Dec 27, 2009 | 63 views

Turn the engine off with the key in the the accessory position so you can see the info display. Press the info button until the Oil Change info is shown. Hold down the info button and it will ask to 'clear', press the info button again. Done!
Good luck

2009 Mitsubishi... | Answered on Dec 09, 2009 | 712 views

Not finding what you are looking for?
2009 Mitsubishi Outlander Logo

141 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides