20 Most Recent 2008 Ford Edge - Page 8 Questions & Answers

well it depends on what type of car you have then i can help you out If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_2094e122cc46f24c

I appreciate your request for my help. However, for either personal or technical reasons I am unable to assist you at this time.

If it is the passenger door, it is the child safety option on the panel with the switches. Check there.

Tire pressure? its all in the owners manual.

If it were me, I'd make a lot of noise-that car is not that old to have a blocked drain-sounds like they are trying to get out of what they should cover, and they chose to treat the cause and not the problem (blower motor failure)-you might only have a bad relay or blown fuse, but I would think they should have checked that out-ask them if they did. Tell them that a plugged drain hose in a 3 year old car is the manufactures fault, and it caused the blower motor to short out-therefore, it should be covered, and call Ford directly if you get no satisfaction-there is no reason that should have happened.

A six way powered seat with memory, will be a complicated creature. Control of such a thing would involve a smart board and several relays. The quickest way to determine if it would be a nightmare to figure out without a wiring chart, is to examine the wire harness that would attach to the car. If it only has a few wires you may be in luck. More than 5, then I wish you luck. Just a few wires will still be a task, but in general the smaller wires would go to the control panel that runs memory functions, and the larger ones would power the internal control board in the seat.

Unfortunately this is a long shot. Your best course of action will likely be to remove the panel with the switches, wire them individually to each respective motor directly through a reversing relay. and find a 12v battery to power it all.

You will need to contact the dealer and they will have to get some information about you and the car before they will give the code, or reset it for you.

those are the ball bearings of the wheel hub needs to be replaced

you need a ford radio removal tool. the radio is probably junk

Unfortuentaly this is a common problem, the only real option is go aftermarket have one installed, go to dealer let them order you a new one, or take to a local radio shop let them repair it.